SGS-6341-Series User Manual

20-89
20.4.4 VLAN Translation Troubleshooting
Normally the VLAN Translation is applied on trunk ports. Normally before using the VLAN
Translation, the dot1q-tunnel function needs to be enabled first to adapt double tag data
packet processes VLAN-translation. When configuring VLAN translation of the egress, make
sure native VLAN of the port is not identical with vid of the packet. Otherwise, the tag of the
packet will be stripped in advance and the transform of vid cannot be completed.
QoS only matches VLAN-id that the packet is translated when VLAN translation and QoS are
configured at the same time.
20.5 Multi-to-One VLAN Translation Configuration
20.5.1 Introduction to Multi-to-One VLAN Translation
Multi-to-One VLAN translation translates the original VLAN ID into the new VLAN ID according
to user’s requirement on uplink traffic, and restores the original VLAN ID on downlink traffic.
Application and configuration of Multi-to-One VLAN translation will be explained in details in
this section.
20.5.2 Multi-to-One VLAN Translation Configuration
Multi-to-One VLAN translation configuration task list:
1. Configure Multi-to-One VLAN translation on the port
2. Show the related configuration of Multi-to-One VLAN translation
1. Configure Multi-to-One VLAN translation on the port
Command Explanation
Port Mode
vlan-translation n-to-1 <WORD> to
<new-vlan-id>
no vlan-translation n-to-1 <WORD>
Configure/delete Multi-to-One VLAN
translation.
User’s Manual of SGS-6341 series