SGS-6341-Series User Manual

17-62
lldp med fast count <value>
no lldp med fast count
When the fast LLDP-MED
startup mechanism is enabled,
it needs to fast send the LLDP
packets with LLDP-MED TLV,
this command is used to set
the value of the fast sending
packets, the no command
restores the default value.
Admin Mode
show lldp
Show the configuration of the
global LLDP and LLDP-MED.
show lldp [interface ethernet <IFNAME>]
Show the configuration of
LLDP and LLDP-MED on the
current port.
show lldp neighbors [interface ethernet <IFNAME>]
Show LLDP and LLDP-MED
configuration of the neighbors.
17.3 LLDP-MED Example
Figure 17-1: Basic LLDP-MED configuration topology
1) Configure Switch A
SwitchA(config)#interface ethernet1/1
SwitchA (Config-If-Ethernet1/1)# lldp enable
SwitchA (Config-If-Ethernet1/1)# lldp mode both（this configuration can be omitted, the
default mode is RxTx）
User’s Manual of SGS-6341 series