SGS-6341-Series User Manual

16-53
For fiber module, verification mode of the receiving power includes inner verification and outer
verification which are decided by the manufacturer. Besides the verification mode of the
real-time parameters and the default thresholds are same.
3. Transceiver monitoring
Besides checking the real-time working state of the transceiver, the user needs to monitor the
detailed status, such as the former abnormity time and the abnormity type. Transceiver
monitoring helps the user to find the former abnormity status through checking the log and
query the last abnormity status through executing the commands. When the user finds the
abnormity information of the fiber module, the fiber module information may be remonitored
after processing the abnormity information, here, the user is able to know the abnormity
information and renew the monitoring.
16.2 DDM Configuration Task List
DDM configuration task list:
1. Show the real-time monitoring information of the transceiver
2. Configure the alarm or warning thresholds of each parameter for the transceiver
3. Configure the state of the transceiver monitoring
（1） Configure the interval of the transceiver monitoring
（2） Configure the enable state of the transceiver monitoring
（3） Show the information of the transceiver monitoring
（4） Clear the information of the transceiver monitoring
1. Show the real-time monitoring information of the transceiver
Command Explanation
Admin and Global Mode
show transceiver [interface ethernet
<interface-list>][detail]
Show the monitoring of the
transceiver.
2. Configur
e the alarm or warning thre
sholds of each parameter for the transceiver
Command Explanation
Port Mode
transceiver threshold {default | {temperature |
voltage | bias | rx-power | tx-power}
{high-alarm | low-alarm | high-warn |
low-warn} {<value> | default}}
Set the threshold defined by the
user.
User’s Manual of SGS-6341 series