User's Manual

7-2
2. Configure the properties for the Ethernet ports
Command
Explanation
Port Mode
combo-forced-mode {copper-forced |
copper-preferred-auto | sfp-forced |
sfp-preferred-auto }
Sets the combo port mode (combo ports only).
shutdown
no shutdown
Enables/Disables specified ports.
name <string>
no name
Names or cancels the name of specified ports.
mdi {auto | across | normal}
no mdi
Sets the cable type for the specified port; this
command is not supported by combo port and
fiber port of switch.
speed-duplex {auto [10 [100 [1000]]
[auto | full | half |]] | force10-half |
force10-full | force100-half |
force100-full | force100-fx
[module-type {auto-detected |
no-phy-integrated | phy-integrated}] |
{{force1g-half | force1g-full}
[nonegotiate [master | slave]]}|
force10g-full}
no speed-duplex
Sets port speed and duplex mode of
100/1000BASE-TX or 100BASE-FX ports.
The no format of this command restores the
default setting, i.e., negotiates speed and
duplex mode automatically.
negotiation {on|off}
Enables/Disables the auto-negotiation
function of 1000BASE-FX ports.
bandwidth control <bandwidth> [both
| receive | transmit]
no bandwidth control
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports.
flow control
no flow control
Enables/Disables traffic control function for
specified ports.
loopback
no loopback
Enables/Disables loopback test function for
specified ports.
rate-suppression {dlf | broadcast |
multicast} <packets>
Enables the storm control function for
broadcasts, multicasts and unicasts with
unknown destinations (short for broadcast),
and sets the allowed broadcast packet
number; the no format of this command
disables the broadcast storm control function.
port-scan-mode {interrupt | poll}
no port-scan-mode
Configure port-scan-mode as interrupt or poll
mode, the no command restores the default
port-scan-mode.