User's Manual

79-13
Case 2：
Figure 83-9: lacp mad detection topology
As shown in the above picture, use the lacp mad detection function between two vsf. Vsf1 and vsf2 are the
devices which are detected and they are also the middle devices. The configuration is same with above.
Proposal: uses create the overlapping connection among the devices to avoid that the vsf1 cannot be the
middle device to detect vsf2 after it is split.
Assume that vsf1 and vsf2 use the lacp ports of ethernet1/1/1, ethernet 1/1/2, ethernet 2/1/1 and ethernet
2/1/2.
vsf1 configuration:
Switch (config)# vsf domain 1
Configure vsf domain number, it can be configured as other value but it cannot be the same as vsf2.
Switch (config)# port-group 1
Switch (config)# interface ethernet 1/1/1
Switch (config-if-ethernet1/1/1)# port-group 1 mode active