User's Manual

52-18
software is installed on the PC and is used in IEEE 802.1x authentication.
Switch(config)#interface vlan 1
Switch(Config-if-vlan1)#ip address 10.1.1.2 255.255.255.0
Switch(Config-if-vlan1)#exit
Switch(config)#radius-server authentication host 10.1.1.3
Switch(config)#radius-server accounting host 10.1.1.3
Switch(config)#radius-server key test
Switch(config)#aaa enable
Switch(config)#aaa-accounting enable
Switch(config)#dot1x enable
Switch(config)#interface ethernet 1/0/2
Switch(Config-If-Ethernet1/0/2)#dot1x enable
Switch(Config-If-Ethernet1/0/2)#dot1x port-control auto
Switch(Config-If-Ethernet1/0/2)#exit
52.3.3 Examples of IPv6 Radius Application
Figure
52-17 IPv6 Radius
Connect the computer to the interface 1/0/2 of the switch, and enable IEEE802.1x on interface1/0/2. Use
MAC based authentication. Configure the IP address of the switch as 2004:1:2:3::2, and connect the switch
with any interface except interface 1/0/2 to the RADIUS authentication server. Configure the IP address of the
RADIUS server to be 2004:1:2:3::3. Use the default ports 1812 and 1813 for authentication and accounting
respectively. Install the IEEE802.1x authentication client software on the computer, and use the client for
IEEE802.1x authentication.
2004:1:2:3::1
2004:1:2:3::2
Radius Server
2004:1:2:3::3