User's Manual

49-30
suppression-query-time
ipv6 mld snooping vlan <vlan-id>
static-group <X:X::X:X> [source <X:X::X:X>]
interface [ethernet | port-channel]
<IFNAME>
no ipv6 mld snooping vlan <vlan-id>
static-group <X:X::X:X> [source <X:X::X:X>]
interface [ethernet | port-channel]
<IFNAME>
Configure static-group on specified port of
the VLAN. The no form of the command
cancels this configuration.
49.7.3 MLD Snooping Examples
Scenario 1: MLD Snooping Function
Figure 49-6 Open the switch MLD Snooping Function figure
As shown above, the vlan 100 configured on the switch consists of ports 1, 2, 6, 10, 12. Four hosts are
respectively connected to 2, 6, 10, 12 while the multicast router on port 1. Suppose we need MLD Snooping
on VLAN 100, however by default, the global MLD Snooping as well as the MLD Snooping on each VLAN are,
therefore first we have to enable the global MLD Snooping at the same time enable the MLD Snooping on
VLAN 100, furthermore we need to set the port 1 of VLAN 100 as a mrouter port.
Configuration procedure is as follows.
Switch#config
Switch(config)#ipv6 mld snooping
Switch(config)#ipv6 mld snooping vlan 100
Switch(config)#ipv6 mld snooping vlan 100 mrouter-port interface ethernet 1/0/1
Multicast configuration:
Assume there are two multicast servers: the Multicast Server 1 and the Multicast Server 2, amongst program
1 and 2 are supplied on the Multicast Server 1 while program 3 on the Multicast server 2, using group
Multicast Router
Mrouter Port
MLD Snooping
Switch
Group1 Group1 Group1 Group2