User's Manual

49-26
ipv6 pim dense-mode | ipv6 pim
sparse-mode
Start MLD Protocol. The NO operation of
corresponding command shuts MLD Protocol.
(Required)
2. Configure MLD auxiliary parameters
（
1
）
Configure MLD group parameters
1） Configure MLD group filter conditions
Command
Explanation
Port Configuration Mode
ipv6 mld access-group
<acl_name>
no ipv6 mld access-group
Configure the filter conditions of i
nterface for
MLD group; the NO operation of this command
cancels filter conditions.
（
2
）
Configure MLD Query parameters
1）Configure interval time for MLD to send query messages
2）Configure the maximum response time of MLD query
3）Configure the overtime of MLD query
Command
Explanation
Port Configuration Mode
ipv6 mld query-interval <time_val>
no ipv6 mld query-interval
Configure the interval of MLD query messages
sent periodically; the NO operation of this
command restores the default value.
ipv6 mld query-max-response-time
<time_val>
no ipv6 mld
query-max-response-time
Configure the maximum response time of the
interface for MLD query; the NO operation of this
command restores the default value.
ipv6 mld query-timeout <time_val>
no ipv6 mld query-timeout
Configure the overtime of the interface for MLD
query; the NO operation of this command
restores the default value.
3. Shut down MLD Protocol
Command
Explanation
Port Configuration Mode
no ipv6 pim dense-mode | no ipv6
pim sparse-mode | no ipv6 pim
multicast-routing (Global Mode)
Shut down MLD Protocol
49.6.3 MLD Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to corresponding vlan,
and start PIM6 on each vlan interface.