User's Manual

Configuration Guide of SGS-6341-Series
2-40
10Gbps SFP+ (10G Ethernet/10GBASE)
Model Speed (Mbps)
Connector
Interface
Fiber Mode Distance Wavelength (nm)
Operating Temp.
MTB-SR
10G
LC
Multi Mode
Up to 300m
850nm
0 ~ 60 degrees C
MTB-LR 10G LC Single Mode 10km 1310nm 0 ~ 60 degrees C
10Gbps SFP+ (10GBASE-BX, Single Fiber Bi-directional SFP)
Model
Speed
(Mbps)
Connector
Interface
Fiber Mode Distance
Wavelength
(TX)
Wavelength
(RX)
Operating Temp.
MTB-LA20
MTB-LB20
10G
WDM(LC)
Single Mode
20km
1270nm
1330nm
0 ~ 60 degrees C
10G
WDM(LC)
Single Mode
20km
1330nm
1270nm
0 ~ 60 degrees C
MTB-LA40
MTB-LB40
10G
WDM(LC)
Single Mode
40km
1270nm
1330nm
0 ~ 60 degrees C
10G WDM(LC) Single Mode 40km 1330nm 1270nm 0 ~ 60 degrees C
MTB-LA60
MTB-LB60
10G
WDM(LC)
Single Mode
60km
1270nm
1330nm
0 ~ 60 degrees C
10G
WDM(LC)
Single Mode
60km
1330nm
1270nm
0 ~ 60 degrees C
It is recommended to use PLANET SFP/SFP+ on the Managed Switch. If you insert an
SFP/SFP+ transceiver that is not supported, the Managed Switch will not recognize it.
1. Before we connect the SGS-6341 series to the other network device, we have to make sure both sides
of the SFP transceivers are with the same media type, for example: 1000BASE-SX to 1000BASE-SX,
1000Bas-LX to 1000BASE-LX.
2. Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
 To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber cable with one side
being the male duplex LC connector type.
 To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with one side
being the male duplex LC connector type.
 Connect the Fiber Cable
1. Insert the duplex LC connector into the SFP/SFP+ transceiver.
2. Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
3. Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure that the
SFP/SFP+ transceiver is operating correctly.
4. Check the Link mode of the SFP/SFP+ port if the link fails. To function with some fiber-NICs or Media
Converters, user has to set the port Link mode to “10G Force”, “1000M Force” or “100M Force”.
 Remove the Transceiver Module
1. Make sure there is no network activity anymore.
2. Remove the Fiber-Optic Cable gently.
3. Lift up the lever of the MGB module and turn it to a horizontal position.
4. Pull out the module gently through the lever.