User's Manual

40-7
2）Cancel default Next-Hop through route map
Command
Explanation
Route mapped configuration command
set ip next-hop <ip-address>
no set ip next-hop
Set the Next-
Hop attribute of outbound
route. The no set ip next-hop command
cancels this setting.
7. Configure EGBP Multi-Hop
If the connections with outer neighbors are not direct, the following command can configure neighbor
Multi-Hop.
Command
Explanation
BGP configuration mode
neighbor {<ip-address>|<TAG>} ebgp-multihop
[<1-255>]
no neighbor {<ip-address>|<TAG>}
ebgp-multihop [<1-255>]
Configure the allowance of EBGP
connection with other networks
that are not connected directly;
the
no neighbor
{<ip-address>|<TAG>}
ebgp-multihop [<1-255>]
command cancels the setting.
8. Configure BGP session identifier
Command
Explanation
BGP configuration mode
bgp router-id <ip-address>
no bgp router-id
Configure the router-id value; the no bgp
router-id
command recovers the default
value.
9. Configure the BGP Version
Command
Explanation
BGP configuration mode
neighbor {<ip-address> | <TAG>} version
<value>
no neighbor {<ip-address> | <TAG>} version
Set the version used by BGP
neighbors; the
no neighbor
{<ip-address> | <TAG>} version
command recovers default
setting. Presently only supporting
version 4
th
.