User's Manual

39-8
（
4
）
Configure Other Parameters of OSPFv3 Protocol
1） Configure OSPFv3 STUB Area & Default Routing Cost
2） Configure OSPFv3 Virtual Link
Commands
Explanation
OSPFv3 Protocol Configuration Mode
timers spf <spf-delay> <spf-holdtime>
no timers spf
Configure OSPFv3 SPF timer. The no
timers spf command recovers default
value.
area <id> stub [no-summary]
no area <id> stub [no-summary]
area <id> default-cost <cost>
no area <id> default-cost
area <id> virtual-link A.B.C.D [instance-id
<instance-id> INTERVAL]
no area <id> virtual-link A.B.C.D
[|INTERVAL]
Configure parameters in OSPFv3 area
(STUB area, Virtual link). The no
command restores default value.
3）Configure the priority of the interface when electing designated layer3 switch (DR).
Commands
Explanation
Interface Configuration Mode
IPv6 ospf priority <priority>
[instance-id <id>]
no IPv6 ospf priority [instance-id
<id>]
Sets the priority of the interface in “designated
layer3 switch” election; the “
no IPv6 ospf
priority [instance-id <id>]” command restores
the default setting.
3. Disable OSPFv3 Protocol
Commands
Explanation
Global Mode
no router IPv6 ospf ospf [<tag>]
Disable OSPFv3 Routing Protocol.
39.3 OSPFv3 Examples
Examples 1: OSPF autonomous system.
This scenario takes an OSPF autonomous system consists of five switch for example.