User's Manual

39-5
Commands
Explanation
Global Mode
[no] router IPv6 ospf <tag>
The command initializes OSPF
v3 routing
process and enter OSPF
v3 mode to
configure OSPFv3 routing process. The [no]
router IPv6 ospf <tag>
command stops
relative process. (required)
OSPFv3 Protocol Configure Mode
router-id <router_id>
no router-id
Configure router for OSPFv3 process. The
no router-id comman
d returns ID to
0.0.0.0 .(required)
[no] passive-interface<ifname>
Configure an interface receiving without
sending. The [no]
passive-interface<ifname>command
cancels configuration.
Interface Configuration Mode
[no] IPv6 router ospf {area <area-id>
[instance-id <instance-id> | tag <tag>
[instance-id <instance-id>]] | tag <tag>
area <area-id> [instance-id
<instance-id>]}
Implement OSPFv3 routing on the interface.
The [no] IPv6 router ospf {area <area-id>
[instance-id <instance-id> | tag <tag>
[instance-id <instance-id>]] | tag <tag>
area <area-id> [instance-id
<instance-id>]}
command cancels
configuration.
2. Configure OSPFv3 parameters
（
1
）
Configure OSPFv3 packet sending mechanism parameters
1）Set the OSPF interface to receive only
2）Configure the cost for sending packets from the interface
Commands
Explanation
Interface Configuration Mode
IPv6 ospf cost <cost> [instance-id
<id>]
no IPv6 ospf cost [instance-id <id>]
Appoint interface to implement required cost of
OSPFv3 protocol. The no IPv6 OSPF cost
[instance-id <id>] restores the default setting.