User's Manual

36-6
4）Configure and apply the route filtering
Command
Explanation
Router configuration mode
distribute-list {< access-list-number
|access-list-name >|prefix<prefix-list-n
ame>}{in|out} [<ifname>]
no distribute-list {< access-list-number
|access-list-name >|prefix<prefix-list-n
ame>}{in|out} [<ifname>]
Configure and apply the access table and prefix
table to filter the routes. The no distribute-list
{< access-list-number
|access-list-name>|prefix<prefix-list-name>}{
in|out} [<ifname>]command means do not use
the access table and prefix table.
5）Configure the split horizon
Command
Explanation
Interface configuration mode
ip rip split-horizon [poisoned]
no ip rip split-horizon
Configure that take the split horizon when the
port sends data packets; poisoned for poison
reverse the no ip rip split-horizon command
cancels the split horizon.
（
3
）
Configure other RIP protocol parameters
1）Configure RIP routing priority
2）Configure the RIP route capacity limit in route table
3）Configure timer for RIP update, timeout and hold-down
4）Configure RIP UDP receiving buffer size
Command
Explanation
Router configuration mode
distance <number> [<A.B.C.D/M> ]
[<access-list-name|access-list-number
>]
no distance [<A.B.C.D/M> ]
Specify the route administratively distance of
RIP protocol; the no distance [<A.B.C.D/M> ]
command restore the default value 120.
maximum-prefix
<maximum-prefix>[<threshold>]
no maximum-prefix <maximum-prefix >
no maximum-prefix
Configure the maximum of RIP route; the no
maximum-prefix <maximum-prefix >
no maximum-prefix command can
cels the
limit.
timers basic <update> <invalid>
<garbage>
no timers basic
Adjust the update, timeout and garbage
collection time, the no timers basic command
restores the default configuration.
recv-buffer-size <size>
no recv-buffer-size
The command conf
igures the UDP receiving
buffer size of the RIP; the no recv-buffer-size
command restores the system default values.
3. Configure RIP-I/RIP-II toggling
（
1
）
Configure the RIP version to be used in all ports