User's Manual

22-39
(6) Configure Tunnel Mode
Command
Explanation
Global mode
ipv6 route <ipv6-address/prefix-length>
{<interface-type interface-number> | tunnel
<tnl-id>}
no ipv6 route <ipv6-address/prefix-length>
{<interface-type interface-number> | tunnel
<tnl-id>}
Configure tunnel routing. The NO
command clears tunnel routing.
22.2.3 IP Configuration Examples
22.2.3.1 Configuration Examples of IPv4
Figure 22-1 IPv4 configuration example
The user’s configuration requirements are: Configure IP address of different network segments on Switch1
and Switch2, configure static routing and validate accessibility using ping function.
Configuration Description:
1． Configure two VLANs on Switch1, namely, VLAN1 and VLAN2.
2． Configure IPv4 address 192.168.1.1 255.255.255.0 in VLAN1 of Switch1, and configure IPv4
address 192.168.2.1 255.255.255.0 in VLAN2.
3． Configure two VLANs on Switch2, respectively VLAN2 and VLAN3.
4． Configure IPv4 address 192.168.2.2 255.255.255.0 in VLAN2 of Switch2, and configure IPv4
address 192.168.3.1 255.255.255.0 in VLAN3.
5． The IPv4 address of PC1 is 192.168.1.100 255.255.255.0, and the IPv4 address of PC2 is
192.168.3.100 255.255.255.0.
6． Configure static routing 192.168.3.0/24 on Switch1, and configure static routing 192.168.1.0/24 on
Switch2.
7． Ping each other among PCs.
Note: First make sure PC1 and Switch1 can access each other by ping, and PC2 and Switch2 can access
each other by ping.
Switch2
Switch1
PC2
PC1