Datasheet
SGS-6341 Series
3
Management
• Management IP for IPv4 and IPv6
• Switch Management Interface
– Console/Telnet Command Line Interface
– Web switch management
– SNMP v1, v2c, and v3 switch management
– SSH/SSL secure access
• BOOTP and DHCP for IP address assignment
• Firmware upload/download via TFTP or HTTP Protocol for
IPv4 and IPv6
• SNTP (Simple Network Time Protocol) for IPv4 and IPv6
• User privilege levels control
• Syslog server for IPv4 and IPv6
• Supports DDM
• Four RMON groups 1, 2, 3, 9 (history, statistics, alarms and
events)
• Supports sFlow
• Supports ULDP
• Supports ULPP (Uplink Protection Protocol)
• Supports ULSM (Uplink State Monitor protocol)
• Supports LLDP/LLDP MED
• Supports DHCP Option82, Option37/38
• Supports ping, trace route function for IPv4 and IPv6
Power over Ethernet (SGS-6341-24P4X)
• Complies with IEEE 802.3at Power over Ethernet Plus, end-
span PSE
• Up to 24 ports of IEEE 802.3af/802.3at devices powered
• Supports PoE power up to 30 watts for each PoE port
• Auto detects powered device (PD)
• Circuit protection prevents power interference between ports
• Remote power feeding up to 100 meters
• PoE management
– Total PoE power budget control
– Per port PoE function enable/disable
– PoE port power feeding priority
– Per PoE port power limitation
– PD classication detection
– PoE schedule
Redundant Power System (SGS-6341-16S8C4XR)
• 100~240V AC / 11-13V DC Dual power redundant
• Active-active redundant power failure protection
• Backup of catastrophic power failure on one supply
ERPS Ring for Metropolitan Area Network Application
Recovery Time < 10ms
Enterprise Branch
Enterprise Branch
SGS-6341-16S8C4XR
SGS-6341-24P4X
Enterprise Branch
Headquarters
SGS-6341 Series
10G
10G
10G
10G
SGS-6341-24T4X
Layer 3 Routing Support
The SGS-6341 series enables the administrator to conveniently boost network eciency
by conguring Layer 3 static routing manually, the RIP (Routing Information Protocol) or
OSPF (Open Shortest Path First) settings automatically.
► The RIP can employ the hop count as a routing metric and prevent routing loops
by implementing a limit on the number of hops allowed in a path from the source
to a destination.
► The OSPF is an interior dynamic routing protocol for autonomous system based
on link state. The protocol creates a database for link state by exchanging link
states among Layer 3 switches, and then uses the Shortest Path First algorithm to
generate a route table based on that database.
Strong Multicast
The SGS-6341 series supports abundant multicast features. In Layer 2, it features IPv4
IGMPv1/v2/v3 snooping and IPv6 MLD v1/v2 snooping. In Layer 3 multicast protocols,
it features IGMPv1/v2/v3 and DVMRP. With Multicast VLAN Register (MVR), multicast
receiver/sender control and illegal multicast source detect functions which make the
SGS-6341 series great for any robust networking.
Full IPv6 Support
The SGS-6341 series provides IPv6 management and enterprise-level secure features
such as SSH, ACL, WRR and RADIUS authentication. It thus helps the enterprises to
step in the IPv6 era with the lowest investment. In addition, you don’t need to replace
the network facilities when the IPv6 FTTx edge network is built.
Robust Layer 2 Features
The SGS-6341 series can be programmed for basic switch management functions such
as port speed configuration, port aggregation, VLAN, Multiple Spanning Tree Protocol,
bandwidth control and IGMP snooping. This switch provides 802.1Q tagged VLAN,
Q-in-Q, voice VLAN and GVRP Protocol functions. By supporting port aggregation, the
SGS-6341 series allows the operation of a high-speed trunk combined with multiple
ports. It enables up to 16 groups for trunking with a maximum of 8 ports for each group.
LACPMSTP
Q-in-Q LLDPQoS
MLD
IGMP
L2/L4
Managed Switch
L2/L4
Managed Switch