Datasheet

SGS-6341-24P4X
2
Centralized Power Management for Gigabit Ethernet PoE Networking
To fulfill the needs of higher power required PoE network applications with Gigabit
speed transmission, the SGS-6341-24P4X features high-performance Gigabit IEEE
802.3af PoE (up to 15.4 watts) and IEEE 802.3at PoE+ (up to 30 watts) on all
ports. It perfectly meets the power requirements of PoE VoIP phone and all kinds
of PoE IP cameras such as IR, PTZ, speed dome cameras or even box type IP
cameras with built-in fan and heater.
The SGS-6341-24P4X’s PoE capabilities also help to reduce deployment costs for
network devices as a result of freeing from the restrictions of power outlet locations.
Power and data switching are integrated into one unit, delivered over a single cable
and managed centrally. It thus eliminates the cost for additional AC wiring and
reduces installation time.
PoE Schedule for Energy Saving
Besides being used for IP surveillance, the SGS-6341-24P4X is certainly applicable
to build any PoE network including VoIP and wireless LAN. Under the trend of
energy saving worldwide and contributing to the environmental protection on the
Earth, the SGS-6341-24P4X can effectively control the power supply besides its
capability of giving high watts power. The “PoE schedule” function helps you to
enable or disable PoE power feeding for each PoE port during specified time
intervals and it is a powerful function to help SMBs or enterprises save energy and
budget.
High Performance 10Gbps Ethernet Capacity
The four SFP+ slots built in the SGS-6341-24P4X boasts a high-performance
switch architecture that is capable of providing non-blocking switch fabric and
wire-speed throughput as high as 128Gbps, which greatly simplifies the tasks
of upgrading the LAN for catering to increasing bandwidth demands. Each of
the SFP+ slots supports Dual-Speed, 10GBASE-SR/LR or 1000BASE-SX/
LX, meaning the administrator now can flexibly choose the suitable SFP/SFP+
transceiver according to the transmission distance or the transmission speed
requiredtoextendthenetworkefciently.
Mode) and PIM-SSM (Protocol Independent Multicast – Source
SpecicMulticast)
• Supports DVMRP (Distance Vector Multicast Routing Protocol)
• Supports IGMP v1/v2/v3 and MLD v1/v2
Layer 2 Features
• Complies with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab,
IEEE 802.3z Gigabit Ethernet standard
• Supports auto-negotiation and half-duplex/full-duplex modes for
all 10BASE-T, 100BASE-TX and 1000BASE-T ports
• Auto-MDI/MDI-X detection on each RJ45 port
• Preventspacketlossowcontrol
– IEEE802.3xpauseframeowcontrolinfull-duplex mode
– Back-pressureowcontrolinhalf-duplexmode
• High performance Store-and-Forward architecture, broadcast
storm control, port loopback detect
• 16K MAC address table, automatic source address learning and
aging
• Supports VLAN
– EEE 802.1Q tag-based VLAN
– GVRP for dynamic VLAN management
– Up to 256 VLANs groups, out of 4041 VLAN IDs
– Provider Bridging (VLAN Q-in-Q, IEEE 802.1ad) supported
– Private VLAN Edge (PVE) supported
– GVRP protocol for Management VLAN
– Protocol-based VLAN
– MAC-based VLAN
– IP subnet VLAN
• Supports Link Aggregation
– Maximum 12 trunk groups, up to 8 ports per trunk group
– IEEE 802.3ad LACP (Link Aggregation Control Protocol)
– Cisco ether-channel (static trunk)
• Supports Spanning Tree Protocol
– STP, IEEE 802.1D (Classic Spanning Tree Protocol)
– RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)
– MSTP, IEEE 802.1s (Multiple Spanning Tree Protocol,
spanning tree by VLAN)
– Supports BPDU & root guard
• Portmirroringtomonitortheincomingoroutgoing trafcona
particular port (many to many)
• Provides port mirror (many-to-1)
Quality of Service
• 8 priority queues on all switch ports
• Support for strict priority and WRR (Weighted Round Robin)
CoS policies
• Trafcclassication
– IEEE 802.1p CoS/ToS
Power
On
Power
On
Power
On
Power
On
6 Watts 6 Watts 12 Watts 12 Watts
PoE
PoE PoE
PoE
Power
Off
Power
Off
Power
Off
Power
On
6 Watts 6 Watts 12 Watts 12 Watts
PoE
PoE PoE
PoE
PoE
1000BASE-T UTP with PoE
Total consumption of 36 watts/hr
5PM8AM
5PM 8AM
Save 24 watts/hr during off-business hours
Total Saved = 10800 Watts/month