(V2) Datasheet

SGS-6341-16S8C4XR
2
Layer 2 Features
• Complies with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab,
IEEE 802.3z Gigabit Ethernet standard
• Supports auto-negotiation and half-duplex/full-duplex modes for
all 10BASE-T, 100BASE-TX and 1000BASE-T ports
• Auto-MDI/MDI-X detection on each RJ45 port
• Prevents packet loss ow control
– IEEE 802.3x pause frame ow control in full-duplex mode
– Back pressure ow control in half-duplex mode
• High performance Store-and-Forward architecture, broadcast
storm control, port loopback detect
• 16K MAC address table, automatic source address learning
and aging
• Supports VLAN
– IEEE 802.1Q tag-based VLAN
– GVRP for dynamic VLAN management
– Up to 256 VLANs groups, out of 4041 VLAN IDs
– Provider Bridging (VLAN Q-in-Q, IEEE 802.1ad) supported
– Private VLAN Edge (PVE) supported
– GVRP protocol for Management VLAN
– Protocol-based VLAN
– MAC-based VLAN
– IP subnet VLAN
• Supports Link Aggregation
– Maximum 128 trunk groups, up to 8 ports per trunk group
– IEEE 802.3ad LACP (Link Aggregation Control Protocol)
– Cisco ether-channel (static trunk)
• Supports Spanning Tree Protocol
– STP, IEEE 802.1D (Classic Spanning Tree Protocol)
– RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)
– MSTP, IEEE 802.1s (Multiple Spanning Tree Protocol,
spanning tree by VLAN)
– Supports BPDU & root guard
• Port mirroring to monitor the incoming or outgoing tra󰀩c on a
particular port (many to many)
• Provides port mirror (many-to-1)
Quality of Service
• 8 priority queues on all switch ports
• Support for strict priority and WRR (Weighted Round Robin)
CoS policies
• Tra󰀩c classication
– IEEE 802.1p CoS/ToS
– IPv4/IPv6 DSCP
– Port-based WRR
• Strict priority and WRR CoS policies
AC and DC Redundant Power to Ensure Continuous Operation
The SGS-6341-16S8C4XR is equipped with one 100~240V AC power supply unit and
one additional 36-75V DC power supply unit for redundant power supply. A redundant
power system is also provided to enhance the reliability with either AC or DC power
supply unit. The redundant power system is specically designed to handle the demands
of high-tech facilities requiring the highest power integrity.
IP Stacking Management
The SGS-6341 series supports IP stacking function that helps network managers to
easily congure up to 24 switches in the same series via one single IP address instead
of connecting and setting each unit one by one. The IP Stacking technology groups
PLANET SGS-6341 switch series together to enable centralized management through a
single unit, regardless of physical location or switch type, as long as they are connected
to the same local network.
High Reliability Hardware Stacking
Two of the 10G SFP+ ports are used to connect several SGS-6341 series build a
virtually logical facility. The SGS-6341 series to gives the enterprises, service providers
and telecoms flexible control over port density, uplinks and switch stack performance.
The SGS-6341 series can connect as a ring for redundancy and ensures that data
integrity is retained even if one switch in the stack fails. You can even hot-swap switches
without disrupting the network, which greatly simplies the tasks of upgrading the LAN for
catering to increasing bandwidth demands.
Layer 3 Routing Support
The SGS-6341 series enables the administrator to conveniently boost network
efficiency by configuring Layer 3 static routing manually, and the RIP or OSPF settings
automatically. The RIP can employ the hop count as a routing metric and prevent routing
loops by implementing a limit on the number of hops allowed in a path from the source
to a destination. The OSPF is an interior dynamic routing protocol for autonomous
system based on link state. The protocol creates a database for link state by exchanging
link states among Layer3 switches, and then uses the Shortest Path First algorithm to
generate a route table based on that database.
Full IPv6 Support
The SGS-6341 series provides IPv6 management and enterprise-level secure features
such as SSH, ACL, WRR and RADIUS authentication. It thus helps the enterprises to
step in the IPv6 era with the lowest investment. In addition, you don’t need to replace the
network facilities when the IPv6 FTTx edge network is built.
IP Stacking
Up to 24 units with SGS-6341 Series
Slave
10G Fiber 10G Fiber
Master
Slave