User's Manual

4-10
[access {<num-std>|<name>}]
[ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
3. Configure IP address of SNMP management base
Command
Explanation
Global Mode
snmp-server securityip { <ipv4-addr> |
<ipv6-addr> }
no snmp-server securityip { <ipv4-addr> |
<ipv6-addr> }
Configure the secure IPv4/IPv6 address which is
allowed to access the switch on the NMS; the no
command deletes configured secure address.
snmp-server securityip enable
snmp-server securityip disable
Enable or disable secure IP address check function
on the NMS.
4. Configure engine ID
Command
Explanation
Global Mode
snmp-server engineid <engine-string>
no snmp-server engineid
Configure the local engine ID on the switch. This
command is used for SNMP v3.
5. Configure user
Command
Explanation
Global Mode
snmp-server user <use-string>
<group-string> [{authPriv | authNoPriv}
auth {md5 | sha} <word>] [access
{<num-std>|<name>}] [ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
no snmp-server user <user-string>
[access {<num-std>|<name>}]
[ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
Add a user to a SNMP group. This command is used
to configure USM for SNMP v3.
6. Configure group
Command
Explanation
Global Mode
snmp-server group <group-string>
{noauthnopriv|authnopriv|authpriv} [[read
<read-string>] [write <write-string>] [notify
<notify-string>]] [access
{<num-std>|<name>}] [ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
no snmp-server group <group-string>
Set the group information on the switch. This
command is used to configure VACM for SNMP v3.