User's Manual

49-9
5) Configure the interface as the management boundary of the PIM-SM6 protocol
Command
Explanation
Interface Configuration Mode
ipv6 pim scope-border
<500-599>|<acl_name>
no ipv6 pim scope-border
To configure PIM-SM6 management boundary
for the interface and apply ACL for the
management boundary. With default settings,
ffx0::/13 is considered as the scope of the
management group. If ACL is configured, then
the scope specified by ACL permit command is
the scope of the management group. acl_name
should be standard IPv6 ACL name. The no
form of this command will remove the
configuration.
（
2
）
Configure global PIM-SM6 parameter
1) Configure the switch as a candidate BSR
Command
Explanation
Global Configuration Mode
ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[hash-mask-length]
[priority]
no Ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[hash-mask-length]
[priority]
This command is the global candidate BSR
configuration command, which is used to
configure the information of PIM-SM candidate
BSR so that it can compete for BSR router with
other candidate BSR. The no operation is to
cancel the configuration of BSR.
2) Configure the switch as a candidate RP
Command
Explanation
Global Configuration Mode
ipv6 pim rp-candiate
{vlan<vlan-id>|
loopback<index>|<ifname>}
[<group range>] [<priority>]
no ipv6 pim rp-candiate
This command is the global candidate RP
configuration command, which is used to
configure the information of PIM-SM candidate
RP so that it can compete for RP router with
other candidate RP. The no
operation is to
cancel the configuration of RP.
3) Configure static RP
Command
Explanation