SGS-6340 Series User Manual

3. Configur
e the RADIUS
server
Command Explanation
Global Mode
radius-server authentication host
{<ipv4-address> | <ipv6-address>} [port
<port-number>] [key {0 | 7} <string>]
[primary] [access-mode {dot1x | telnet}]
no radius-server authentication host
{<ipv4-address> | <ipv6-address>
Specifies the IPv4/IPv6 address and the
port number, whether be primary server for
RADIUS accounting server; the no
command deletes the RADIUS accounting
server.
radius-server accounting host
{<ipv4-address> | <ipv6-address>} [port
<port-number>] [key {0 | 7} <string>]
[primary]
no radius-server accounting host
{<ipv4-address> | <ipv6-address>}
Specifies the IPv4/IPv6 address and the
port number, whether be primary server for
RADIUS accounting server; the no
command deletes the RADIUS accounting
server.
4. Configure the parameter of the RADIUS service
Command Explanation
Global Mode
radius-server dead-time <minutes>
no radius-server dead-time
To configure the interval that the RADIUS
becomes available after it is down. The no
form of this command will restore the
default configuration.
radius-server retransmit <retries>
no radius-server retransmit
To configure retry times for the RADIUS
packets. The no form of this command
restores the default configuration.
radius-server timeout <seconds>
no radius-server timeout
To configure the timeout value for the
RADIUS server. The no form of this
command will restore the default
configuration.
radius-server accounting-interim-update
timeout <seconds>
no radius-server
accounting-interim-update timeout
To configure the update interval for
accounting. The no form of this command
will restore the default configuration.
47-112