SGS-6340 Series User Manual

6. Display
related configuration information of AM
Command Explanation
Global Mode
show am [interface <interface-name>]
Display the AM configuration information
of one port or all ports.
44.3 AM Function Example
………
Internet
Port1 Port2
SWITCH
HUB2 HUB1
PC1 PC2 PC30
Figure 44
-1:
a typical configuration example of AM function
In the topology above, 30 PCs, after converged by HUB1, connect with interface1 on the
switch. The IP addresses of these 30 PCs range from 100.10.10.1 to 100.10.10.30.
Considering security, the system manager will only take user with an IP address within that
range as legal ones. And the switch will only forward data packets from legal users while
dumping packets from other users.
According to the requirements mentioned above, the switch can be configured as follows:
Switch(config)#am enable
Switch(config)#interface ethernet1/1
Switch(Config-If-Ethernet 1/1)#am port
Switch(Config-If-Ethernet 1/1)#am ip-pool 10.10.10.1 10
44-101