SGS-6340 Series User Manual

User’s Manual of SGS-6340 seriesT
SGS-6340-16XR Front Panel
Figure 2-4 SGS-6340-16XR Front Panel
■ Gigabit TP interface
10/100/1000BASE-T Copper, RJ45 Twisted-pair: Up to 100 meters.
■ Gigabit SFP slots
100/1000BASE-X mini-GBIC slot, SFP (Small Factor Pluggable) transceiver module: From 550 meters to 2km
(multi-mode fiber), up to above 10/20/30/40/50/70/120 kilometers (single-mode fiber). Only
SGS-6340-20S4C4X supports 100BASE-FX.
■ 10 Gigabit SFP slot
10GBASE-SR/LR mini-GBIC slot, SFP (Small Factor Pluggable) Transceiver Module supports from 300
meters (Multi-mode Fiber), up to 10 kilometers (Single Mode Fiber)
■ Console Port
The console port is a RJ45 port connector. It is an interface for connecting a terminal directly. Through the
console port, it provides rich diagnostic information including IP Address setting, factory reset, port
management, link status and system setting. Users can use the attached DB9 to RJ45 console cable in the
package and connect to the console port on the device. After the connection, users can run any terminal
emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm and so on) to enter the startup screen of
the device.
■ Reset button
On the front panel, the reset button is designed for rebooting the Managed Switch without turning off and on
the power.
■ DC Power Connector (SGS-6340-20S4C4X only)
The front panel of the Managed Switch contains a power switch and a DC power connector, which accepts DC
power input voltage from -48V to -60V DC. Connect the power cable to the Managed Switch at the input
terminal block.
The wire gauge for the terminal block should be in the range of 12 ~ 24 AWG.
18