SGS-6340 Series User Manual

debug ospf redistribute message send
no debug ospf redistribute message
send
debug ospf redistribute route receive
no debug ospf redistribute route
receive
Enable or disable debugging of sending
command from OSPF process redistributed
to other OSPF process routing.
Enable or disable debugging of received
routing message from NSM for OSPF
process.
（4）Configure other OSPF protocol parameters
1）Configure how to calculate OSPF SPF algorithm time
2）Configure the LSA limit in the OSPF link state database
3）Configure various OSPF parameters
Command Explanation
OSPF Protocol Configuration Mode
timers spf <interval>
no timers spf
Configure the SPF timer of OSPF; the
no timers spf command restores the
default settings.
overflow database {<max-LSA> [hard | soft]
| external <max-LSA> <recover time>}
no overflow database [external <max-LSA
> < recover time >]
Configure the LSA limit in current OSPF
process database; the no overflow
database [external < max-LSA > <
recover time >] command restores the
default settings.
area <id> {authentication [message-digest]
| default-cost <cost> | filter-list {access |
prefix} <WORD> {in | out} | nssa
[default-information-originate |
no-redistribution | no-summary |
translator-role] | range <range> | stub
[no-summary] | virtual-link <neighbor>}
no area <id> {authentication | default-cost |
filter-list {access | prefix} <WORD> {in |
out} | nssa [default-information-originate |
no-redistribution | no-summary |
translator-role] | range <range> | stub
[no-summary] | virtual-link <neighbor>}
Configure the parameters in OSPF area
(STUB area, NSSA area and virtual
links); the no area <id> {authentication
| default-cost | filter-list {access |
prefix} <WORD> {in | out} | nssa
[default-information-originate |
no-redistribution | no-summary |
translator-role] | range <range> | stub
[no-summary] | virtual-link
<neighbor>} command restores the
default settings.
4）Configure the priority of the interface when electing designated Layer 3 switch (DR).
Command Explanation
Interface Configuration Mode
ip ospf priority <priority>
no ip ospf priority
Sets the priority of the interface in “designated
Layer 3 switch” election; the no ip ospf priority
command restores the default setting.
26-33