SGS-6340 Series User Manual

14-45
3. Configure remote failure
Command Explanation
Port Mode
ethernet-oam remote-failure
no ethernet-oam remote-failure
Enable remote failure detection of
EFM OAM (failure means
critical-event or link-fault event of the
local), no command disables the
function. (optional)
ethernet-oam errored-symbol-period
threshold high {high-symbols | none}
no ethernet-oam errored-symbol-period
threshold high
Configure the high threshold of
errored symbol period event, no
command restores the default value.
(optional)
ethernet-oam errored-frame-period threshold
high {high-frames | none}
no ethernet-oam errored-frame-period
threshold high
Configure the high threshold of
errored frame period event, no
command restores the default value.
(optional)
ethernet-oam errored-frame threshold high
{high-frames | none}
no ethernet-oam errored-frame threshold high
Configure the high threshold of
errored frame event, no command
restores the default value. (optional)
ethernet-oam errored-frame-seconds
threshold high {high-frame-seconds | none}
no ethernet-oam errored-frame-seconds
threshold high
Configure the high threshold of
errored frame seconds event, no
command restores the default value.
(optional)
14.3 EFM OAM Example
Example:
CE and PE devices with point-to-point link enable EFM OAM to monitor “the First Mile” link
performance. It will report the log information to network management system when occurring
fault event and use remote loopback function to detect the link in necessary instance
Figure 14-3: Typical
OAM application topology