User's Manual

User’s Manual of SGS-5240 Series Managed Switch
266
 MD Index – Domain index. (Range: 1-65535)
 MD Name – Maintenance domain name. (Range: 1-43 alphanumeric characters)
 MD Level – Authorized maintenance level for this domain. (Range: 0-7)
 MIP Creation Type – Specifies the CFM protocol’s creation method for maintenance intermediate points (MIPs) in this
domain:
 Default – MIPs can be created for any maintenance association (MA) configured in this domain on any bridge
port through which the MA’s VID can pass.
 Explicit – MIPs can be created for any MA configured in this domain only on bridge ports through which the MA’s
VID can pass, and only if a maintenance end point (MEP) is created at some lower MA Level.
 None – No MIP can be created for any MA configured in this domain.
4.8.7.4 MD Details
Device Management > CFM > MD Details page is used to configure details of specify MD.
 MD Index – Domain index. (Range: 1-65535)
 MEP Archive Hold Time – The time that data from a missing MEP is retained in the continuity check message (CCM)
database before being purged. (Range: 1-65535 minutes; Default: 100 minutes) A change to the hold time only applies to
entries stored in the database after this attribute is changed.
 MEP Fault Notify Lowest Priority – The lowest priority defect that is allowed to generate a fault alarm. (Range: 1-6,
Default: 2)
 MEP Fault Notify Alarm Time – The time that one or more defects must be present before a fault alarm is issued.
(Range: 3-10 seconds; Default: 3 seconds)
 MEP Fault Notify Reset Time – The time after a fault alarm has been issued, and no defect exists, before another fault
alarm can be issued. (Range: 3-10 seconds; Default: 10 seconds)