User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 System Information
- 4.2 Switch Management
- 4.2.1 Jumbo Frame
- 4.2.2 Interface
- 4.2.3 Statistics
- 4.2.4 VLAN
- 4.2.5 MAC Address
- 4.2.6 Port Mirror
- 4.2.7 Static Link Aggregation
- 4.2.8 LACP
- 4.2.9 Trunk Group Load Balance
- 4.2.10 Spanning Tree Protocol
- 4.2.11 IGMP Snooping
- 4.2.12 IGMP Filtering and Throttling
- 4.2.13 MLD Snooping
- 4.2.14 MVR For IPv4
- 4.2.14.1 Configure Global
- 4.2.14.2 Configure Domain
- 4.2.14.3 Show Configure Profile
- 4.2.14.4 Add Configure Profile
- 4.2.14.5 Show Associate Profile
- 4.2.14.6 Add Associate Profile
- 4.2.14.7 Configure Interface
- 4.2.14.8 Show Static Group Member
- 4.2.14.9 Add Static Group Member
- 4.2.14.10 Show Member
- 4.2.14.11 Show Query Statistics
- 4.2.14.12 Show VLAN Statistics
- 4.2.14.13 Show Port Statistics
- 4.2.14.14 Show Group Statistics
- 4.2.15 MVR For IPv6
- 4.2.15.1 Configure Global
- 4.2.15.2 Configure Domain
- 4.2.15.3 Show Configure Profile
- 4.2.15.4 Add Configure Profile
- 4.2.15.5 Show Associate Profile
- 4.2.15.6 Add Associate Profile
- 4.2.15.7 Configure Interface
- 4.2.15.8 Show Static Group Member
- 4.2.15.9 Add Static Group Member
- 4.2.15.10 Show Member
- 4.2.15.11 Show Query Statistics
- 4.2.15.12 Show VLAN Statistics
- 4.2.15.13 Show Port Statistics
- 4.2.15.14 Show Group Statistics
- 4.2.16 LLDP
- 4.2.17 ERPS
- 4.2.18 Loopback Detection
- 4.2.19 UDLD
- 4.2.20 Rate Limit
- 4.2.21 Storm Control
- 4.2.22 Stacking
- 4.2.23 Pepo
- 4.3 Route Management
- 4.4 ACL
- 4.5 CoS
- 4.6 Qu’s
- 4.7 Security
- 4.7.1 AAA
- 4.7.2 Web Authentication
- 4.7.3 802.1X
- 4.7.4 MAC Authentication
- 4.7.5 HTTPS
- 4.7.6 SSH
- 4.7.7 Port Security
- 4.7.8 DAI – Dynamic ARP Inspection
- 4.7.9 Login IP Management
- 4.7.10 DoS Protection
- 4.7.11 IPv4 DHCP Snooping
- 4.7.12 IPv6 DHCP Snooping
- 4.7.13 IPv4 Source Guard
- 4.7.14 IPv6 Source Guard
- 4.7.15 Application Filter
- 4.7.16 CPU Guard
- 4.8 Device Management
- 4.8.1 SNMP
- 4.8.2 RMON
- 4.8.3 Cluster
- 4.8.4 DNS
- 4.8.5 DHCP
- 4.8.6 OAM
- 4.8.7 CFM
- 4.8.7.1 Global Configuration
- 4.8.7.2 Interface Configuration
- 4.8.7.3 MD Management
- 4.8.7.4 MD Details
- 4.8.7.5 MA Management
- 4.8.7.6 MA Details
- 4.8.7.7 MEP Management
- 4.8.7.8 Remote MEP Management
- 4.8.7.9 Transmit Link Trace
- 4.8.7.10 Transmit Loopback
- 4.8.7.11 Transmit Delay Measure
- 4.8.7.12 Show Local MEP
- 4.8.7.13 Show Local MEP Details
- 4.8.7.14 Show Local MIP
- 4.8.7.15 Show Remote MEP
- 4.8.7.16 Show Remote MEP Details
- 4.8.7.17 Show Link Trace Cache
- 4.8.7.18 Show Fault Notification Generator
- 4.8.7.19 Show Continuity Check Error
- 4.8.8 Time Setting
- 4.8.9 Event Log
- 4.8.10 File Management
- 4.8.11 Ping
- 4.8.12 Trace Route
- 4.8.13 System Reboot
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A: Networking Connection
- APPENDIX B : GLOSSARY
User’s Manual of SGS-5240 Series Managed Switch
164
◆Software Revision – The software revision of the end-point device.
◆Manufacture Name – The manufacturer of the end-point device
◆Asset ID – The asset identifier of the end-point device. End-point devices are typically assigned asset identifiers to facilitate
inventory management and assets tracking.
◆Firmware Revision – The firmware revision of the end-point device.
◆Serial Number – The serial number of the end-point device.
◆Model Name – The model name of the end-point device.
◆Asset ID – The asset identifier of the end-point device.
4.2.16.6 Statistics
Switch Management > LLDP >Show Statistics page is used to display statistics for LLDP-capable devices attached to the switch,
and for LLDP protocol messages transmitted or received on all local interfaces.
◆Neighbor Entries List Last Updated – The time the LLDP neighbor entry list was last updated.
◆New Neighbor Entries Count – The number of LLDP neighbors for which the remote TTL has not yet expired.
◆Neighbor Entries Deleted Count – The number of LLDP neighbors which have been removed from the LLDP remote
systems MIB for any reason.
◆Neighbor Entries Dropped Count – The number of times which the remote database on this switch dropped an LLDPDU
because of insufficient resources.
◆Neighbor Entries Age-out Count – The number of times that a neighbor’s information has been deleted from the LLDP remote
systems MIB because the remote TTL timer has expired. Port/Trunk
◆Frames Discarded – Number of frames discarded because they did not conform to the general validation rules as well as
any specific usage rules defined for the particular TLV.
◆Frames Invalid – A count of all LLDPDUs received with one or more detectable errors.
◆Frames Received – Number of LLDP PDUs received.
◆Frames Sent – Number of LLDP PDUs transmitted.
◆TLVs Unrecognized – A count of all TLVs not recognized by the receiving LLDP local agent.
◆TLVs Discarded – A count of all LLDPDUs received and then discarded due to insufficient memory space, missing or
out-of-sequence attributes, or any other reason.
◆Neighbor Ageouts – A count of the times that a neighbor’s information has been deleted from the LLDP remote systems MIB
because the remote TTL timer has expired.