Quick Guide

10
4.3 Setting1000BASE-XforSFP+Port
TheManagedSwitchsupports both1000BASE-Xand 10GBASE-XSFPtransceiver
bymanualsettingandthedefaultSFP+portspeedissetto10Gbps.
For example, to establish the ber connection with 1000BASE-XSFP transceiverin
the Ethernet 1/25,thefollowingcommandcongurationisrequired:
Switch#cong terminal
Switch(cong)#interface ethernet 1/25
Switch(cong-if)#speed-duplex 1000full
Figure 4-6: Setting 1000BASE-X Screen
4.4 SavingtheConguration
InManagedSwitch, therunning congurationlestores in theRAM. Inthe current
version, the running conguration sequence running-cong can be saved from the
RAM to FLASH by copy running-cong startup-cong command, so that the
running conguration sequence becomes the start-up conguration le, which is
calledcongurationsave.
Switch# copy running-cong startup-cong
Startupcongurationlename:startup1.cfg