User's Manual

4. Installing QSFP+ Transceiver Module
4-1 Install the QSFP+ Ethernet Transceiver
Module
Please follow these steps to install the QSFP+ Ethernet
transceiver module:
1. Power on the Switch and place the Switch on a at
surface. Install the new QSFP+ Ethernet transceiver
module by inserting it into the slot and sliding it in until
it stops (See Figure 1). Press it rmly until you hear
the module snap into place. Never force, twist or bend
the QSFP+ Ethernet transceiver module. The QSFP+
Ethernet transceiver module slides in smoothly and the
Switch will automatically detect the new module.
2. After the Fiber connection is done successfully, check the LEDs to verify whether there is a link and a proper
connection at the port.
Please refer to the user’s manual for more about the Switch or module’s management.
4-2 Remove the QSFP+ Ethernet Transceiver Module
1. Make sure there is no network activity by consulting or checking
with the network administrator.
2. Remove the Fiber Optic Cable gently.
3. Turn the handle or pull out the tab of the QSFP+ Ethernet Trans-
ceiver module gently.
Warning
Never pull out the QSFP+ Ethernet Transceiver
module without pulling the handle or the push
bolts on the module. Directly pulling out the QSFP+
Ethernet Transceiver module would damage the
QSFP+ Ethernet Transceiver module.
Appendix A
A.1 Fiber Optic Cable Connection Parameters
The wiring details are shown below:
 Fiber Optic Patch Cables:
Standard Fiber Type Cable Specications
40GBASE-SR4 Multi-mode 50/125μm
40GBASE-LR4 Single mode 9/125μm
Safety Notice
Fiber optic SFP modules are equipped with a Class 1 laser, which emits invisible radiation. Read the following
safety warnings carefully:
Note
Class 1 Laser Product
Complies with FDA Regulation 21 CFR 1040.10 and 1040.11
Warning
Class 1 radiation is present when the device or system is powered up.
Warning
Only trained and qualified personnel should be allowed to install or replace these modules.
PLANET Technology Corp.
10F., No 96, Minquan Rd., Xindian Dist.,
New Taipei City 231, Taiwan 2350-AG0890-000
Figure 1: Insert the QSFP+ Ethernet Transceiver Module
QSFP+ Ethernet Transceiver
100m~10km
QSFP+ Ethernet Transceiver
100m~10km
QSFP+ Ethernet Transceiver
100m~10km
QSFP+ Ethernet Transceiver
100m~10km