00GBASE-SR4 QSFP28 Fiber Transceiver QSFP-100G-SR4/QSFP-100G-LR4
User’s Manual of QSFP-100G-SR4/QSFP-100G-LR4 Trademarks Copyright PLANET Technology Corp. 2018 Contents are subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners.
User’s Manual of QSFP-100G-SR4/QSFP-100G-LR4 Table of Contents 1. Overview ...................................................................................................... 4 2. Checklist ...................................................................................................... 4 3. Introduction and Model List .......................................................................... 4 3-1 The QSFP-100G Series Ethernet Transceiver Module List ..............................................
User’s Manual of QSFP-100G-SR4/QSFP-100G-LR4 1. Overview Thank you for purchasing PLANET QSFP28 Transceiver which includes the Ethernet module of the QSFP-100G-SR4 and QSFP-100G-LR4. The QSFP28 100G Ethernet modules can be installed in PLANET switch products with 100G QSFP28 interface. The QSFP28 transceivers can be extended from a distance of 100m (multimode, MPO) to up to 10km (single-mode, LC). 2.
User’s Manual of QSFP-100G-SR4/QSFP-100G-LR4 Figure 1: Inserting the QSFP28 Ethernet Transceiver Module 2. After the Fiber connection is done successfully, check the LEDs to verify whether there is a link and a proper connection at the port. Please refer to the user’s manual for more about the Switch or module’s management. 4-2 Removing the QSFP28 Ethernet Transceiver Module 1. Make sure there is no network activity by consulting or checking with the network administrator. 2.
User’s Manual of QSFP-100G-SR4/QSFP-100G-LR4 Never pull out the QSFP28 Ethernet Transceiver module without pulling the handle or the push bolts on the module. Directly pulling out the QSFP28 Ethernet Transceiver module would damage the QSFP28 Ethernet Transceiver module.
User’s Manual of QSFP-100G-SR4/QSFP-100G-LR4 Appendix A A.1 Fiber Optic Cable Connection Parameters The wiring details are shown below: ■ Fiber Optic Patch Cables: Standard Fiber Type Cable Specifications 100GBASE-SR4 Multi-mode 50/125μm 100GBASE-LR4 Single mode 9/125μm Safety Notice Fiber optic SFP modules are equipped with a Class 1 laser, which emits invisible radiation. Read the following safety warnings carefully: Class 1 Laser Product Complies with FDA Regulation 21 CFR 1040.10 and 1040.
