Switch User Manual

10
Figure 2-7 Network application installation
The PoE Injector Hub supports Data passive mode, that is, even the PoE Injector Hub is manual power off, the data
between “
D
ATA” port and “DATA+PoE” port can still be transmitted without data loss.
The POE-1200 / POE-2400 Mid-Span Injector Hub doesn’t support Gigabit data rate. The Ethernet
switches or PoE PDs with Gigabit interface will operate at 100Mpbs Full Duplex mode when connect
to the Mid-Span Injector Hub.
2.2.4 Power over Ethernet Powered Device
3~5 watts
Voice over IP phones
Enterprise can install POE VoIP Phone, AT
A and other Ethernet/non-Ethernet
end-devices to the central where UPS
is installed for un-interrupt power system
and power control system.
6~12 watts
Wireless LAN Access Points
Museum, Sightseeing, Airport, Hotel, Campus, F
actory,
Warehouse can install
the Access Point any where with no hesitation
10~12 watts
IP Surveillance
Enterprise, Museum, Campus, Hospital, Bank, can install IP Camera w
ithout
limits of install location – no need electrician to install AC sockets.
3~12 watts
PoE Splitter
PoE Splitter split the PoE 48V DC over
the Ethernet cable into 5/9/12V DC
power
output. It frees the device deployment from restrictions due to power
outlet locations, which eliminate the costs for additional AC wiring and reduces
the installation time.