User's Manual
Table Of Contents
- Copyright
- Declaration
- Contents
- Chapter 1 Outlines and Features
- Chapter 2 NVR Appearance
- Chapter 3 Connecting NVR
- Chapter 4 NVR Startup
- Chapter 5 NVR Menu
- Chapter 6 Web Operation
- 6.1 Internet connection
- 6.2 Browser Login
- 6.3 Active X download, installation
- 6.4 Live View
- 6.5 Configuration
- 6.5.1 Local Config
- 6.5.2 Camera
- 6.5.3 Storage
- 6.5.3.1 Channel Recording
- Step 1: In the main interface, click "Configuration → Storage→ Channel Recording" to enter the recording setting interface, as shown in Figure 6-14 below.
- Figure 6-14
- Step 2: Set parameters, see the table below.
- Table 6-1
- Step 3: Click "Save" to complete configuration.
- Encode
- In the main interface, click "Configuration →Record →Encode" to enter the encoding setting interface, as shown in Figure 6-15 below. Here you can view and set the encoding parameter values for accessing the IPC. The relevant parameters and NVR-side se...
- Figure 6-15
- 6.5.3.2 Storage Manage
- HDD
- In the main interface, click "Configuration →Storage →Storage Manage" to enter the HDD interface, as shown in Figure 6-16 below. Here you can view the HDD information of the connected device and format the hard disk. The operation steps of formatting ...
- Figure 6-16
- Cloud Storage
- In the main interface, click "Configuration →System →Network →Cloud Storage" to enter Cloud Storage and IPEYE setting interface, as shown in Figure 6-17 below. Here you could enable and set the function of Cloud Storage and IPEYE, the specific setting...
- Figure 6-17
- 6.5.4 System
- 6.5.5 Maintain
- 6.6 Playback
- 6.7 Picture
- Chapter 7 Appendix
H.265 25-ch 4K Network Video Recorde with 16-Port PoE
NVR-2500 Series
95
PTZ setup interface is used to set the PTZ direction, speed and lens zoom,
focus and aperture settings and cruise settings shortcut button.
Channel: Select the channel where the dome camera is connected to
the NVR.
Zoom: Adjust the camera magnification by
/ key, long-range /
wide-angle function.
Focus: Use the
/ key, zoom in/out function, adjust the camera
to focus.
Iris: Use the
/ key, zoom in / out the aperture function, adjust
the aperture of the camera.
Speed: It is mainly used to set the pan/tilt rotation speed operation. For
example, the rotation speed in step 7 is much greater than the rotation
speed in step size 1.
Preset setting: Through the direction of the button to turn the PTZ to
the desired location, and then click the preset button below the "set"
button to complete the preset point settings.
Cruise setting: After selecting the cruise line, click the setting button,
select the preset number, dwell time (seconds) and cruise speed in the
pop-up cruise line setting interface, as shown in Figure 5-30
○
2 , click
"OK" button, Return to the cruise settings screen and click "Cruise on"
again to save the settings and make the device start cruising.