User's Manual
Table Of Contents
- Copyright
- Declaration
- Contents
- Chapter 1 Outlines and Features
- Chapter 2 NVR Appearance
- Chapter 3 Connecting NVR
- Chapter 4 NVR Startup
- Chapter 5 NVR Menu
- Chapter 6 Web Operation
- 6.1 Internet connection
- 6.2 Browser Login
- 6.3 Active X download, installation
- 6.4 Live View
- 6.5 Configuration
- 6.5.1 Local Config
- 6.5.2 Camera
- 6.5.3 Storage
- 6.5.3.1 Channel Recording
- Step 1: In the main interface, click "Configuration → Storage→ Channel Recording" to enter the recording setting interface, as shown in Figure 6-14 below.
- Figure 6-14
- Step 2: Set parameters, see the table below.
- Table 6-1
- Step 3: Click "Save" to complete configuration.
- Encode
- In the main interface, click "Configuration →Record →Encode" to enter the encoding setting interface, as shown in Figure 6-15 below. Here you can view and set the encoding parameter values for accessing the IPC. The relevant parameters and NVR-side se...
- Figure 6-15
- 6.5.3.2 Storage Manage
- HDD
- In the main interface, click "Configuration →Storage →Storage Manage" to enter the HDD interface, as shown in Figure 6-16 below. Here you can view the HDD information of the connected device and format the hard disk. The operation steps of formatting ...
- Figure 6-16
- Cloud Storage
- In the main interface, click "Configuration →System →Network →Cloud Storage" to enter Cloud Storage and IPEYE setting interface, as shown in Figure 6-17 below. Here you could enable and set the function of Cloud Storage and IPEYE, the specific setting...
- Figure 6-17
- 6.5.4 System
- 6.5.5 Maintain
- 6.6 Playback
- 6.7 Picture
- Chapter 7 Appendix
H.265 25-ch 4K Network Video Recorde with 16-Port PoE
NVR-2500 Series
93
Image enhancement: Here you can select the flicker control mode, turn
on and set the wide dynamic intensity.
Flicker control : The flicker control mode is selected according to
the IPC installation environment and the flicker standard. The PAL
standard is 50HZ and the NTSC standard is 60HZ. When the device
is installed outdoors, it can be selected outdoor. The default setting
is PAL.
Sensor linear WDR: The default is "Shutdown", you can switch the
wide dynamic strength (Automatic, Weak, Moderate, Strong, Super)
in the drop-down menu.
Defog mode: Used to set the defogging mode and strength.
Defog mode: The default is off, and you can select on or Auto from
the drop-down menu.
Defog strength: The default is 0. When the defogging mode is on,
the defogging intensity can be set. The range of values can be set
from 0 to 255.
The camera image interface only displays the device
support functions. The specific interface is subject to
the actual product.