User's Manual
Table Of Contents
- Copyright
- Declaration
- Contents
- Chapter 1 Outlines and Features
- Chapter 2 NVR Appearance
- Chapter 3 Connecting NVR
- Chapter 4 NVR Startup
- Chapter 5 NVR Menu
- Chapter 6 Web Operation
- 6.1 Internet connection
- 6.2 Browser Login
- 6.3 Active X download, installation
- 6.4 Live View
- 6.5 Configuration
- 6.5.1 Local Config
- 6.5.2 Camera
- 6.5.3 Storage
- 6.5.3.1 Channel Recording
- Step 1: In the main interface, click "Configuration → Storage→ Channel Recording" to enter the recording setting interface, as shown in Figure 6-14 below.
- Figure 6-14
- Step 2: Set parameters, see the table below.
- Table 6-1
- Step 3: Click "Save" to complete configuration.
- Encode
- In the main interface, click "Configuration →Record →Encode" to enter the encoding setting interface, as shown in Figure 6-15 below. Here you can view and set the encoding parameter values for accessing the IPC. The relevant parameters and NVR-side se...
- Figure 6-15
- 6.5.3.2 Storage Manage
- HDD
- In the main interface, click "Configuration →Storage →Storage Manage" to enter the HDD interface, as shown in Figure 6-16 below. Here you can view the HDD information of the connected device and format the hard disk. The operation steps of formatting ...
- Figure 6-16
- Cloud Storage
- In the main interface, click "Configuration →System →Network →Cloud Storage" to enter Cloud Storage and IPEYE setting interface, as shown in Figure 6-17 below. Here you could enable and set the function of Cloud Storage and IPEYE, the specific setting...
- Figure 6-17
- 6.5.4 System
- 6.5.5 Maintain
- 6.6 Playback
- 6.7 Picture
- Chapter 7 Appendix
H.265 25-ch 4K Network Video Recorde with 16-Port PoE
NVR-2500 Series
91
5.3.5.4 Image
In Image Color interface, the Brightness, Contrast, Saturation and Sharpness
of IP channel video can be adjusted, related parameters for the IPC can also
be set, such as Fill light, Exposure setting, Backlight setting, White balance
and Video adjustment.
The specific operation steps are as follows:
Step 1: In the main menu, click "
→Image" to enter Image configuration
interface, as shown in Figure 5-33 below.
Figure 5-33
Steps 2: Select the channel for image configuration.
Steps 3: Adjust the image parameters of the channel.
User can drag the slider to adjust the parameters.
The Image adjustment, Fill light, Exposure setting, Backlight
setting, White balance, Video adjustment, Image
enhancement and Defog mode can be adjusted.
Adjusting the parameters of the video will not only change
the preview effect of the image, but also the video quality
of the image. Please operate with CAUTION.