User's Manual
Table Of Contents
- Copyright
- Declaration
- Contents
- Chapter 1 Outlines and Features
- Chapter 2 NVR Appearance
- Chapter 3 Connecting NVR
- Chapter 4 NVR Startup
- Chapter 5 NVR Menu
- Chapter 6 Web Operation
- 6.1 Internet connection
- 6.2 Browser Login
- 6.3 Active X download, installation
- 6.4 Live View
- 6.5 Configuration
- 6.5.1 Local Config
- 6.5.2 Camera
- 6.5.3 Storage
- 6.5.3.1 Channel Recording
- Step 1: In the main interface, click "Configuration → Storage→ Channel Recording" to enter the recording setting interface, as shown in Figure 6-14 below.
- Figure 6-14
- Step 2: Set parameters, see the table below.
- Table 6-1
- Step 3: Click "Save" to complete configuration.
- Encode
- In the main interface, click "Configuration →Record →Encode" to enter the encoding setting interface, as shown in Figure 6-15 below. Here you can view and set the encoding parameter values for accessing the IPC. The relevant parameters and NVR-side se...
- Figure 6-15
- 6.5.3.2 Storage Manage
- HDD
- In the main interface, click "Configuration →Storage →Storage Manage" to enter the HDD interface, as shown in Figure 6-16 below. Here you can view the HDD information of the connected device and format the hard disk. The operation steps of formatting ...
- Figure 6-16
- Cloud Storage
- In the main interface, click "Configuration →System →Network →Cloud Storage" to enter Cloud Storage and IPEYE setting interface, as shown in Figure 6-17 below. Here you could enable and set the function of Cloud Storage and IPEYE, the specific setting...
- Figure 6-17
- 6.5.4 System
- 6.5.5 Maintain
- 6.6 Playback
- 6.7 Picture
- Chapter 7 Appendix
H.265 25-ch 4K Network Video Recorde with 16-Port PoE
NVR-2500 Series
88
Adding mode can be set to "Manual" or "Plug and
Play" in the POE NVR, which is not settable in the
normal NVR.
Before using the upgrade function, copy the upgrade
package corresponding to the device to be upgraded
to a USB flash drive and insert the USB flash drive into
the NVR.
When you upgrade multiple IP devices, you can only
select the same IP device. During the upgrade, all IP
devices cannot be powered off. Otherwise, the
upgrade fails or the device cannot start.
5.3.5.2 PoE
PoE is used to view and set the power supply of each PoE channel of NVR. It
consists of PoE Power Configuration and PoE Bonding Configuration.
PoE Power Configuration
The specific operation steps are as follows:
Step 1: In the main menu, click "
→POE→PoE Power Configuration" to
enter PoE Power Configuration interface, as shown in Figure 5-30 below.
Figure 5-30