User's Manual
Table Of Contents
- Copyright
- Declaration
- Contents
- Chapter 1 Outlines and Features
- Chapter 2 NVR Appearance
- Chapter 3 Connecting NVR
- Chapter 4 NVR Startup
- Chapter 5 NVR Menu
- Chapter 6 Web Operation
- 6.1 Internet connection
- 6.2 Browser Login
- 6.3 Active X download, installation
- 6.4 Live View
- 6.5 Configuration
- 6.5.1 Local Config
- 6.5.2 Camera
- 6.5.3 Storage
- 6.5.3.1 Channel Recording
- Step 1: In the main interface, click "Configuration → Storage→ Channel Recording" to enter the recording setting interface, as shown in Figure 6-14 below.
- Figure 6-14
- Step 2: Set parameters, see the table below.
- Table 6-1
- Step 3: Click "Save" to complete configuration.
- Encode
- In the main interface, click "Configuration →Record →Encode" to enter the encoding setting interface, as shown in Figure 6-15 below. Here you can view and set the encoding parameter values for accessing the IPC. The relevant parameters and NVR-side se...
- Figure 6-15
- 6.5.3.2 Storage Manage
- HDD
- In the main interface, click "Configuration →Storage →Storage Manage" to enter the HDD interface, as shown in Figure 6-16 below. Here you can view the HDD information of the connected device and format the hard disk. The operation steps of formatting ...
- Figure 6-16
- Cloud Storage
- In the main interface, click "Configuration →System →Network →Cloud Storage" to enter Cloud Storage and IPEYE setting interface, as shown in Figure 6-17 below. Here you could enable and set the function of Cloud Storage and IPEYE, the specific setting...
- Figure 6-17
- 6.5.4 System
- 6.5.5 Maintain
- 6.6 Playback
- 6.7 Picture
- Chapter 7 Appendix
H.265 25-ch 4K Network Video Recorde with 16-Port PoE
NVR-2500 Series
44
Click to enter the HDD interface, where you can view the hard
disk status, capacity and other related information.
Click to enter the network status interface, where you can view
the device's IP address, subnet mask, gateway and other
network information.
Click into the system information interface. (Detailed operation
as 5.1.2).
Poll: Click into the poll setup interface (Detailed operation as
5.1.3)
Turn on / off the channel name and channel number of each
channel.
Turn on / off all-day timing recording for all channels
Screen
split
Screen splitting will divide the screen into 1, 4, 9, 16, etc.
according to the number of devices supported by
the NVR.
Exit full screen, click to enter the main menu mode.
Table 5-1
At present, only some equipment of the company
supports fisheye correction.
Multi-screen display depends on the maximum number
of channels supported by the device. For example, there
are 9 screens in the shortcut menu of the 9-channel
device and 16 screens in the 16-channel device shortcut
menu.