User's Manual

H.265 25-ch 4K Network Video Recorde with 16-Port PoE
NVR-2500 Series
204
6.5.2.3 Image
In the main interface, click "Configuration →Camera →Image" to enter the
Image setting interface, as shown in Figure 6-10 below. Here you can view
and set the channel image (brightness, contrast, saturation and sharpness),
fill light, exposure, backlight, white balance, video adjustment, image
enhancement and defogging, etc. The relevant parameters are consistent
with the local settings of the NVR.
Figure 6-10
6.5.2.4 PTZ Setup (NVR-2516P)
In the main interface, click "Configuration → Channel → PTZ Setup" to enter
the video PTZ Setup interface, as shown in Figure 6-11. Here you can view
and set the PTZ channel connected to RS485 such as protocol, address, baud
rate, etc. of the PTZ channel connected to RS485. All parameters (baud rate,
data bit, stop bit, check, protocol, address) should be connected to the cloud.
The parameters of the decoders are the same. The relevant parameters are
consistent with the NVR-side settings.