User's Manual
Table Of Contents
- Copyright
- Declaration
- Contents
- Chapter 1 Outlines and Features
- Chapter 2 NVR Appearance
- Chapter 3 Connecting NVR
- Chapter 4 NVR Startup
- Chapter 5 NVR Menu
- Chapter 6 Web Operation
- 6.1 Internet connection
- 6.2 Browser Login
- 6.3 Active X download, installation
- 6.4 Live View
- 6.5 Configuration
- 6.5.1 Local Config
- 6.5.2 Camera
- 6.5.3 Storage
- 6.5.3.1 Channel Recording
- Step 1: In the main interface, click "Configuration → Storage→ Channel Recording" to enter the recording setting interface, as shown in Figure 6-14 below.
- Figure 6-14
- Step 2: Set parameters, see the table below.
- Table 6-1
- Step 3: Click "Save" to complete configuration.
- Encode
- In the main interface, click "Configuration →Record →Encode" to enter the encoding setting interface, as shown in Figure 6-15 below. Here you can view and set the encoding parameter values for accessing the IPC. The relevant parameters and NVR-side se...
- Figure 6-15
- 6.5.3.2 Storage Manage
- HDD
- In the main interface, click "Configuration →Storage →Storage Manage" to enter the HDD interface, as shown in Figure 6-16 below. Here you can view the HDD information of the connected device and format the hard disk. The operation steps of formatting ...
- Figure 6-16
- Cloud Storage
- In the main interface, click "Configuration →System →Network →Cloud Storage" to enter Cloud Storage and IPEYE setting interface, as shown in Figure 6-17 below. Here you could enable and set the function of Cloud Storage and IPEYE, the specific setting...
- Figure 6-17
- 6.5.4 System
- 6.5.5 Maintain
- 6.6 Playback
- 6.7 Picture
- Chapter 7 Appendix
H.265 25-ch 4K Network Video Recorde with 16-Port PoE
NVR-2500 Series
189
5.3.8.4 HDD Operation
S.M.A.R.T
S.M.A.R.T is used to monitor the temperature of the hard disk, the surface
material of the disk, the motor and its drive system, and analyze and predict
the possible problems of the hard disk.
The specific operation steps are as follows:
Step 1: In the main menu, choose "
→S.M.A.R.T" to enter S.M.A.R.T
interface, as shown in Figure 5-89 below.
Figure 5-89
Step 2: Select the hard disk to be tested and set "Self-Test Type".
Step 3: The device starts to detect the hard disk.
Step 4: After the hard disk is detected, the hard disk details will be displayed
in the S.M.A.R.T. information list.
S.M.A.R.T Configuration:
Disk No: Pull down to select the drive number.
Test condition: Shows whether the hard disk has been detected.
Test type: Short and extended.
Temperature: Display hard disk temperature.
Utility time (h): Shows how long the hard disk is used (hours).
Self-assessment: Show whether the hard disk is passed.