Manualshelf

User's Manual

ManualsBrandsPLANET Technology ManualsNMS ControllerUniversal Network Management Controller with LCD Touch Screen (10"/12")
11121314151617181920
Table Of Contents
12
Device Setting
Switch: Log in to the Switch’s Web User Interface and refer to the picture below to enable the SNMP and
LLDP function as shown in Figures 1 and 2.
AP: Log in to the AP’s Web User Interface and refer to Figure 3 below to configure the AP to “Managed AP".
Then, click “Apply Change”. To support SNMP AP, enable the SNMP function.
IP Cam: The ONVIF function is enabled by default.