User's Manual

- 15 -
The AP will reboot automatically to make your wireless configuration to take effect and finish the Setup.
 Router Mode
Step 1. Select the WAN Access Type.
Step 2. Enter the information for the selected WAN Access Type, and then click Next. If your access
type is DHCP Client, then you can get the IP address from the ISP, so you do not need to
enter the information like other modes. For other modes, please refer to the section WAN
Interface Setup.
Step 3. Click the Finished button. You will then see the Finish page as shown below.
The AP will reboot automatically to make your wireless configuration to take effect and finish the Setup.