User's Manual

Table Of Contents
Users Manual of MGSD-10080F
388
The page includes the following fields:
Object Description
Port
The logical port for the settings.
Remote IP Address
This is an IP address of the remote device.
Ping Size
The payload size of the ICMP packet. Values range from 8 bytes to 1400 bytes.
Ping Button
This is a button for you to send 5 ICMP ping packets to the remote device.
Result
Display the ping result.
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
: Clears the IP Address and the result of ping value.
4.7.2.4 Cable Diagnostics
This page is used for running the Cable Diagnostics.
Press to run the diagnostics. This will take approximately 5 seconds. If all ports are selected, this can take approximately 15
seconds. When completed, the page refreshes automatically, and you can view the cable diagnostics results in the cable status
table. Note that Cable Diagnostics is only accurate for cables of length 7 - 140 meters.
10 and 100 Mbps ports will be linked down while running cable diagnostic. Therefore, running cable diagnostic on a 10 or 100
Mbps management port will cause the switch to stop responding until VeriPHY is complete. The VeriPHY Cable Diagnostics
screen in Figure 4-7-2-4 appears.
Figure 4-7-2-4: VeriPHY Cable Diagnostics Page Screenshot