User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web page
- 4.2 System
- 4.2.1 Management
- 4.2.1.1 System Information
- 4.2.1.2 IP Configuration
- 4.2.1.3 IP Status
- 4.2.1.4 ARP Table
- 4.2.1.5 Users Configuration
- 4.2.1.6 Privilege Levels
- 4.2.1.7 NTP Configuration
- 4.2.1.7.1 System Time Correction Manually
- 4.2.1.8 Time Configuration
- 4.2.1.9 UPnP
- 4.2.1.10 DHCP Relay
- 4.2.1.11 DHCP Relay Statistics
- 4.2.1.12 CPU Load
- 4.2.1.13 System Log
- 4.2.1.14 Detailed Log
- 4.2.1.15 Remote Syslog
- 4.2.1.16 SMTP Configuration
- 4.2.1.17 Fault Alarm
- 4.2.1.18 Digital Input/Output
- 4.2.2 Simple Network Management Protocol
- 4.2.3 RMON
- 4.2.4 DHCP server
- 4.2.5 Remote Management
- 4.2.1 Management
- 4.3 Switching
- 4.3.1 Port Management
- 4.3.2 Link Aggregation
- 4.3.3 VLAN
- 4.3.3.1 VLAN Overview
- 4.3.3.2 IEEE 802.1Q VLAN
- 4.3.3.3 VLAN Port Configuration
- 4.3.3.4 VLAN Membership Status
- 4.3.3.5 VLAN Port Status
- 4.3.3.6 Private VLAN
- 4.3.3.7 Port Isolation
- 4.3.3.8 VLAN setting example:
- 4.3.3.9 MAC-based VLAN
- 4.3.3.10 IP Subnet-based VLAN Membership Configuration
- 4.3.3.11 Protocol-based VLAN
- 4.3.3.12 Protocol-based VLAN Membership
- 4.3.2.13 VLAN Translation
- 4.3.4 Spanning Tree Protocol
- 4.3.5 Multicast
- 4.3.6 MLD Snooping
- 4.3.7 MVR (Multicast VLAN Registration)
- 4.3.8 LLDP
- 4.3.9 MAC Address Table
- 4.3.10 Loop Protection
- 4.3.11 UDLD
- 4.3.12 GVRP
- 4.3.13 PTP
- 4.3.14 Link OAM
- 4.4 Quality of Service
- 4.4.2 Bandwidth Control
- 4.4.4.2 DSCP-based QoS
- 4.5 Security
- 4.6 Ring
- 4.7 Maintenance
- 5. COMMAND LINE MODE
- 6. SWITCH OPERATION
- 7. TROUBLESHOOTING
- APPENDIX A: Networking Connection
- APPENDIX B : GLOSSARY
User’s Manual of MGSD-10080F
37
Gigabit Ethernet Transceiver (1000BASE-X SFP)
Model DDM Speed (Mbps)
Connector
Interface
Fiber Mode Distance Wavelength (nm)
Operating Temp.
MGB-GT -- 1000 Copper -- 100m --
0 ~ 60 ℃
MGB-SX(V2) YES 1000 LC Multi Mode 550m 850nm
0 ~ 60 ℃
MGB-SX2(V2) YES 1000 LC Multi Mode 2km 1310nm
0 ~ 60 ℃
MGB-LX(V2) YES 1000 LC Single Mode 20km 1310nm
0 ~ 60 ℃
MGB-L40 YES 1000 LC Single Mode 40km 1310nm
0 ~ 60 ℃
MGB-L80 YES 1000 LC Single Mode 80km 1550nm
0 ~ 60 ℃
MGB-L120(V2) YES 1000 LC Single Mode 120km 1550nm
0 ~ 60 ℃
Gigabit Ethernet Transceiver (1000BASE-BX, Single Fiber Bi-directional SFP)
Model DDM Speed (Mbps)
Connector
Interface
Fiber Mode Distance
Wavelength (TX)
Wavelength (RX)
Operating Temp.
MGB-LA10(V2)
MGB-LB10(V2)
YES
1000 WDM(LC) Single Mode 10km 1310nm 1550nm
0 ~ 60 ℃
1000 WDM(LC) Single Mode 10km 1550nm 1310nm
0 ~ 60 ℃
MGB-LA20(V2)
MGB-LB20(V2)
YES
1000 WDM(LC) Single Mode 20km 1310nm 1550nm
0 ~ 60 ℃
1000 WDM(LC) Single Mode 20km 1550nm 1310nm
0 ~ 60 ℃
MGB-LA40(V2)
MGB-LB40(V2)
YES
1000 WDM(LC) Single Mode 40km 1310nm 1550nm
0 ~ 60 ℃
1000 WDM(LC) Single Mode 40km 1550nm 1310nm
0 ~ 60 ℃
MGB-LA80
MGB-LB80
YES
1000 WDM(LC) Single Mode 80km 1490nm 1550nm
0 ~ 60 ℃
1000 WDM(LC) Single Mode 80km 1550nm 1490nm
0 ~ 60 ℃
Gigabit Ethernet Transceiver (2500BASE-X SFP)
Model DDM Speed (Mbps)
Connector
Interface
Fiber Mode Distance Wavelength (nm)
Operating Temp.
MGB-2GSR YES 2500 LC Multi Mode 300m 850nm
0 ~ 70 ℃
MGB-2GLR2 YES 2500 LC Single Mode 2km 1310nm
0 ~ 70 ℃
MGB-2GLR20 YES 2500 LC Single Mode 20km 1310nm
0 ~ 70 ℃
MGB-2GLA20
YES
2500
LC
Single Mode 20km
TX:1310nm
RX:1550nm
0 ~ 70 ℃
MGB-2GLB20
YES
2500
LC
Single Mode 20km
TX:1550nm
RX:1310nm
0 ~ 70 ℃
It is recommended to use PLANET SFP on the Managed Metro Switch. If you insert an SFP
transceiver that is not supported, the Managed Metro Switch will not recognize it.
Connect the fiber cable
1. Attach the duplex LC connector on the network cable to the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a media
converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Managed Metro Switch. Ensure that the SFP transceiver is
operating correctly.