Datasheet

MGSD-10080F
7
Specications
Product
MGSD-10080F
HardwareSpecications
SFP Fiber Optic Ports
6 1000BASE-SX/LX/BX SFP interfaces, from port 1 to port 6
Compatible with 100BASE-FX SFP.
2 100/1000/2500BASE-X SFP interfaces, from port 7 to port 8
Copper Ports 2 10/ 100/1000BASE-T RJ45 auto-MDI/MDI-X ports (Port-9 and Port-10)
Console 1 x RJ45 serial port (115200, 8, N, 1)
Reset Button
< 5 sec: System reboot
> 5 sec: Factory default
Power Requirements
AC 100~240V, 50/60Hz 0.15A
-36V DC @ 0.3A, Range: -36V ~ -60V DC
Power Consumption
Max. 11.2 watts/38.2 BTU (AC input)
Max. 10.8 watts/36.9 BTU (DC input)
Alarm One relay output for power failure. Alarm Relay current carry ability: 1A @ DC 24V
DI/DO
2 Digital Input (DI): Level 0: -24V~2.1V (±0.1V)
Level 1: 2.1V~24V (±0.1V)
Input Load to 24V DC, 10mA max.
2 Digital Output (DO): Open collector to 24VDC, 100mA max.
ESD Protection 6KV DC
Dimensions (W x D x H) 330 x 155 x 43.5 mm, 1U high
Weight 1661g
LED
System:
PWR (Green)
DC 1 (Green)
DC 2 (Green)
Fault Alarm (Green)
Ring (Green)
Ring Owner (Green)
Per Gigabit SFP Ports: Port 1 to Port 6.
100 LNK/ACT (Orange)
1G LNK/ACT (Green)
Per Gigabit SFP Ports: Port 7 to Port 8.
100 LNK/ACT (Orange)
1G/2.5G LNK/ACT (Green)
Per Gigabit RJ45 Ports: Port 9 to Port 10.
10/100 LNK/ACT (Orange)
1G LNK/ACT (Green)
Switching
Switch Architecture Store-and-Forward
Switch Fabric 26Gbps/non-blocking
Throughput (packet per second) 19.3Mpps @ 64Bytes packet
Address Table 8K entries, automatic source address learning and aging
SDRAM 256Mbits
Flash 64Mbytes
Flow Control
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex
Jumbo Frame 9KB
Layer 2 Functions
PortConguration
Port disable / enable
Auto-Negotiation 10/100/1000Mbps full and half duplex mode selection
Flow Control disable / enable
Bandwidth control on each port
Power saving mode control
Port Status Displayeachport’sspeedduplexmode,linkstatus,owcontrolstatus,autonegotiationstatus,trunkstatus
Port Mirroring
TX/RX/Both
1 to 1 monitor