User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.2.1 Management
- 4.2.1.1 System Information
- 4.2.1.2 IP Configuration
- 4.2.1.3 IP Status
- 4.2.1.4 ARP
- 4.2.1.5 Users Configuration
- 4.2.1.6 Privilege Levels
- 4.2.1.7 NTP Configuration
- 4.2.1.8 Time Configuration
- 4.2.1.9 Time Configuration
- 4.2.1.10 UPnP
- 4.2.1.11 CPU Load
- 4.2.1.12 System Log
- 4.2.1.13 Detailed Log
- 4.2.1.14 Remote Syslog
- 4.2.1.15 SMTP Configuration
- 4.2.2 SNMP
- 4.2.3 RMON
- 4.2.4 DHCP Relay
- 4.2.5 DHCP server
- 4.2.6 Remote Management
- 4.2.1 Management
- 4.3 Switching
- 4.3.1 Port Management
- 4.3.2 Link Aggregation
- 4.3.3 VLANs
- 4.3.4 VLAN Translation
- 4.3.5 VLAN Translation Mappings
- 4.3.6 Private VLANs
- 4.3.7 VCL
- 4.3.8 GVRP
- 4.3.9 MRP
- 4.3.10 Spanning Tree
- 4.3.11 IGMP Snooping
- 4.3.12 MLD Snooping
- 4.3.13 MVR (Multicast VLAN Registration)
- 4.3.14 LLDP
- 4.3.15 MAC Address Table
- 4.3.16 Loop Protection
- 4.3.17 UDLD
- 4.3.18 Link OAM
- 4.3.19 CFM
- 4.3.20 sFlow
- 4.4 Routing
- 4.5 QoS
- 4.6 Security
- 4.7 POE
- 4.8 Ring
- 4.9 ONVIF
- 4.10 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A: Networking Connection
- APPENDIX B : GLOSSARY
User’s Manual of GS-6320 and MGS-6320 Managed Switches
236
• Mode
The Mode in which the Link OAM is operating, Active or Passive.
• Unidirectional
Operation Support
This feature is not available to be configured by the user. The status of this
configuration is retrieved from the PHY.
• Remote Loopback
Support
If status is enabled, DTE is capable of OAM remote loopback mode.
• Link Monitoring
Support
If status is enabled, DTE supports interpreting Link Events.
• MIB Retrieval Support
If status ie enabled DTE supports sending Variable Response OAMPDUs.
• MTU Size
It represents the largest OAMPDU, in octets, supported by the DTE.
This value is compared to the remotes Maximum PDU Size and the smaller of
the two is used.
• Multiplexer State
When in forwarding state, the Device is forwarding non-OAMPDUs to the lower
sublayer. Incase of discarding, the device discards all the non-OAMPDU's.
• Parser State
When in forwarding state, Device is forwarding non-OAMPDUs to higher
sublayer.
When in loopback, Device is looping back non-OAMPDUs to the lower
sublayer.
When in discarding state, Device is discarding non-OAMPDUs.
• Organizational Unique
Identification
24-bit Organizationally Unique Identifier of the vendor.
• PDU Revision
It indicates the current revision of the Information TLV.
The value of this field shall start at zero and be incremented each time something
in the Information TLV changes. Upon reception of an Information TLV from a
peer, an OAM client may use this field to decide if it needs to be processed (an
Information TLV that is identical to the previous Information TLV doesn't need to
be parsed as nothing in it has changed).
Buttons
Click to refresh the page immediately.
Auto-refresh : Check this box to enable an automatic refresh. Automatic refresh occurs every 3 seconds.
4.3.18.3 Event Status
This page allows the user to inspect the current Link OAM Link Event configurations, and change them as well. as screen in
Figure 4-3-18-3 appears.