User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. HARDWARE INSTALLATION
- 3. MANAGED MEDIA CONVERTER CHASSIS MANAGEMENT
- 4. CONSOLE INTERFACE
- 5. WEB MANAGEMENT
- 6. LINK PASS THROUGH FUNCTION
- 7. TROUBLESHOOTING
- APPENDIX A NETWORKING CONNECTION
Item Description
Device To enable or disable per FST-80x Converter board.
LLCF To enable or disable the LLCF function from FST-80x Converter board.
TP AN Mode To set the UTP port runs at Auto-negotiation or Forced Mode.
TP Speed＊ To set the UTP port runs at 100Mbps or 10Mbps.
TP Duplex＊ To set the UTP port runs at Full duplex or Half duplex mode.
TP FC To set the Flow Control of the UTP port to enable or disable.
Fiber LLR To enable or disable the LLR function of the Fiber port.
Fiber Duplex To set the Duplex Mode of Fiber port to Full duplex or Half duplex mode.
Table 5-3 Descriptions of the FST-80x slot Configuration screen Objects
#
Notice:
＊: Only set the TP port run at force mode, the TP speed and TP duplex function are available.
Figure 5-7 GST-70x Converter Status Web Page screen
Item Description
Device To enable or disable per GST-70x Converter board.
Fiber LLR To enable or disable the LLR function of the Fiber port.
Fiber AN Bypass To set the Auto negotiation bypass function of the Fiber port to enable or disable.
Table 5-4 Descriptions of the GST-70x slot Configuration screen Objects
42