User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. HARDWARE INSTALLATION
- 3. MANAGED MEDIA CONVERTER CHASSIS MANAGEMENT
- 4. CONSOLE INTERFACE
- 5. WEB MANAGEMENT
- 6. LINK PASS THROUGH FUNCTION
- 7. TROUBLESHOOTING
- APPENDIX A NETWORKING CONNECTION
Factory Default Reset the Managed Media Converter Chassis to factory default mode.
Reboot Reboot the Managed Media Converter Chassis.
Logout Logout console interface of Managed Media Converter Chassis.
Table 4-1 Detail description of Managed Media Converter Chassis available commands
#
Notice:
Only accept command in lowercase letter under console interface.
4.4.2 Show command
From the main menu screen (see Figure 4-3), input “show” and press enter. The show command list screen in Figure 4-5
appears.
Figure 4-5 Show command list screen
This show command list contains five items:
Show system: Please refer to chapter 4.4.2.1.
Show IP: Please refer to chapter 4.4.2.2.
Show power: Please refer to chapter 4.4.2.3.
Show slot [n]: Please refer to chapter 4.4.2.4
Show redundant [n]: Please refer to chapter 4.4.2.5
25