User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. HARDWARE INSTALLATION
- 3. MANAGED MEDIA CONVERTER CHASSIS MANAGEMENT
- 4. CONSOLE INTERFACE
- 5. WEB MANAGEMENT
- 6. LINK PASS THROUGH FUNCTION
- 7. TROUBLESHOOTING
- APPENDIX A NETWORKING CONNECTION
4. CONSOLE INTERFACE
4.1 CONNECT TO PC
RS-232 serial cable
Use the bundled RS-232 serial cable and attach the 9-pin female connector to the male connector on the Managed Media
Converter Chassis. Plug the other side of this cable to your PC.
Hyper Terminal
In Windows 98/2000/ME/XP, launch “HyperTerminal”, create a new connection, and adjust settings as below:
Emulation: VT-100 compatible
Baud per second: 38400
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None
To gain a demo, please see the Figure 4-1.
Figure 4-1 Port Settings for console interface
22