User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A
- EC Declaration of Conformity
User’s Manual of LRP-822CS/LRP-1622CS
340
4.16 Maintenance
ce menu items to di
maintenance, the following topics are p upgrade, save and restore the configuration. This section has the
■ Factory Default
Yo
■ Reboot Switch Yo s page. After restart, the switch will boot
o
■ Backup Manager
Yo
■ Upgrade Manager
Yo the switch configuration.
Se
Default
You can reset the configuration of the s n is retained. The new configuration is
available immediately, which means th k
to reset the configuration to Factory D
Use the Maintenan splay and configure basic configura
tions of the LRP Managed Switch. Under
rovided to back up,
following items:
u can reset the configuration of the switch on this page.
u can restart the switch on thi
n rmally.
u can back up the switch configuration.
u can upgrade
■ Dual Image lect active or backup image on this page.
4.16.1 Factory
witch on this page. Only the IP configuratio
at no restart is necessary. The Factory Default screen in Figure 4-15-1 appears and clic
efaults.
Figure 4-15-1 Factory Default Page Screenshot
nd rebooted, the system will load the default IP settings as follows:
8.0.100
.0
After the “Factory” button is pressed a
。 Default IP address: 192.16
。 Subnet mask: 255.255.255
。 Default Gateway: 192.168.
。 The other setting value is b
0.254
ack to disable or none.
To reset the LRP Managed Switch to the factory default setting, you can also press the hardware reset
button on the front panel for about 10 seconds. After the device is rebooted, you can login the
management Web interface within the same subnet of 192.168.0.xx.