Datasheet

Data Sheet
1
LRP-822CS
1
8-port Coax + 2-port 10/100/1000T + 2-port 100/1000X
SFP Long Reach PoE over Coaxial Managed Switch
PLANET Long Reach PoE Solution enables all enterprises and network service
providers to set up an IP infrastructure in a remote location where 802.3af/at PoE
compliant powered devices can receive both data and power via PLANET switches, and
PLANET LRP extenders and injectors over a long distance but not limited to the normal
100 meters.
Intelligent Long Reach PoE Switch on Coaxial-based Network
PLANET LRP-822CS, a brand-new Multi-channel Long Reach PoE Switch, features
an extended Ethernet and PoE networking of up to 1,000 meters over the existing
coaxial cables going to multiple PoE IP cameras. It provides IPv6 / IPv4 dual stack
management and built-in L2/L4 Gigabit Switching engine along with 8 BNC ports with
Long Reach PoE Injector function, 2 Gigabit copper ports and 2 extra 100/1000BASE-X
SFP fiber slots. Each of the eight BNC ports provides 36 watts of power with a total
power budget of up to 240 watts. As an advanced PoE switch, the LRP-822CS features
intelligent PoE functions to improve the availability of critical applications. It provides a
quick, safe and cost-effective PoE network solution to upgrading the existing coaxial
cable infrastructure from the analog system to the HD IP surveillance system.
Physical Port
• 8 100Mbps BNC female ports with Long Reach PoE Injector
function
• 2 10/100/1000BASE-T Gigabit RJ45 copper ports
• 2 100/1000BASE-X mini-GBIC/SFP slots
• RJ45 console interface for switch basic management and setup
Long Reach Power over Ethernet
• Supports PoE power up to 36 watts for each PoE port
• Remotepowerfeedingupto 1kilometerwith5C2V/RG675Ω
coaxial cable
• Long Reach PoE Management
–
Total Long Reach PoE power budget control
–
Per port Long Reach PoE function enable/disable
–
Long Reach PoE port power feeding priority
–
Per Long Reach PoE port power limitation
–
Long Reach PD alive check
–
Long Reach PoE schedule
Layer 2 Features
• Prevents packet loss with back pressure (half-duplex) and IEEE
802.3xpauseframeowcontrol (full-duplex)
• High performance Store and Forward architecture, broadcast storm
control,runt/CRClteringthateliminateserroneouspacketsto
optimize the network bandwidth
• Supports VLAN
–
IEEE 802.1Q tagged VLAN
–
Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
–
Protocol VLAN
–
Voice VLAN
–
Private VLAN
–
Management VLAN
–
GVRP
• Supports Spanning Tree Protocol
–
STP (Spanning Tree Protocol)
–
RSTP (Rapid Spanning Tree Protocol)
–
MSTP (Multiple Spanning Tree Protocol)
–
STP BPDU Guard, BPDU Filtering and BPDU Forwarding
• Supports Link Aggregation
–
IEEE 802.3ad Link Aggregation Control Protocol (LACP)
–
Cisco ether-channel (static trunk)
–
Maximum 4 trunk groups, up to 4 ports per trunk group
• Provides port mirror (many-to-1)
• Loop protection to avoid broadcast loops
Quality of Service
• Ingress / Egress rate limit per port bandwidth control
• Storm control support
–
Broadcast / Unknown unicast / Unknown multicast
RJ45 Type Console Port
2 x 10/100/1000BASE-T
2 x 100/1000BASE-X SFP Slot
8 x 100Mbps Long Reach PoE BNC Port