User Manual

User’s Manual of LRP-422CST
provides rich diagnostic information including IP Address setting, factory reset, port management, link status and system
setting.
Users can use the attached DB9 to RJ45 console cable in the package and connect to the console port on the device. After
the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm and so on)
to enter the startup screen of the device.
■ Reset Button
On the left of the front panel, the reset button is designed to reboot the LRP Managed Switch without turning off and on the
power. The following is the summary table of the Reset button functions:
Reset Button Pressed and Released Function
< 5 sec: System Reboot Reboot the LRP Managed Switch.
> 5 sec: Factory Default
Reset the LRP Managed Switch to the Factory Default
configuration. The LRP Managed Switch will then reboot and
load the default settings shown below:
。 Default Username: admin
。 Default Password: admin
。 Default IP Address: 192.168.0.100
。 Subnet Mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
2.1.3 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; it helps monitor and troubleshoot
when needed.
■ System/Alert
LED Color Function
P1 Green
Lights
To indicate power 1 has power.
P2 Green
Lights
To indicate power 2 has power.
Fault Red
Lights
To indicate either power 1 or power 2 has no power.
■ Long Reach PoE Interfaces (Port-1 to Port-4)
LED Color Function
LNK Green Lights
To indicate the link through that port is successfully established.
PoE Orange Lights
To indicate the port is providing DC in-line power.
■ 10/100/1000BASE-T Interfaces (GE1 to GE2)
LED Color Function
LNK/ACT Green Lights
To indicate the link through that port is successfully established.
26