User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A
User’s Manual of LRP-422CST
1.5 Product Specifications
Model LRP-422CST
Hardware Specifications
Copper
2 x 10/100/1000BASE-T RJ45
Auto-negotiation/Auto-MDI/MDI-X
Fiber Optic
2 x 100/1000BASE-X SFP slot
Supports 100/1000Mbps dual mode and DDM
Ethernet
Interfaces
Jumbo Frame
10Kbytes with GE1 to GE4
Connectivity
4 x BNC female connectors
Long Reach PoE over coaxial PSE (Power Source Equipment)
BNC center pole : DC+/Hi
BNC shield : DC -/Lo
Power Output
Per port 48~56V DC, 36 watts (max.)
Total Power Budget
150 watts (max.)
Cabling
Coaxial cable: 75 ohm
RG-6/U cable (Recommended)
Maximum Distance
Max. 200m with PoE+ output (1,640ft.)
Max. 400m with PoE output (2,624ft.)
Max. 1200m without PoE output (3,937ft.)
Long Reach
Ethernet Standard
IEEE 1901
Modulation Type Wavelet-OFDM
Security 128-bit AES encryption
Frequency Band 2 ~ 28MHz
Data Rate (Mbps)*
RG-6/U
Distance
TX** RX**
LRP-101CE
PoE Output(W)@25 degrees C*
200m 93.9 93.5 21.7
400m 90.4 90.3 19.04
600m 82.1 80 13.5
800m 69.6 69.4 10.35
1000m 52.2 50.2 8.01
1200m 31.7 37.8 -
Performance
* The actual data rate and PoE output vary on the quality of the copper wire and
environmental factors. The performance result above is based on the testing via
the RG-6/U coaxial cable.
** TX: The LRP-422CST to the LRP-101CE
RX: The LRP-101CE to the LRP-422CST
Multiple Nodes
Up to 4 LRP extenders within 1km RG-6/U coaxial cable*
* The actual extender nodes vary on the quality of the copper wire and
environmental factors.
Long Reach PoE
Interfaces
LRP Compatibility
LRP-101CE: 1-Port 10/100TX PoE PSE + 1-Port Coax Long Reach PoE
20